SICO SAS Series Datasheet

DUAL HEIGHT STEPS
SAS SERIES
ASSEMBLY INSTRUCTIONS
AND PARTS LIST
Printed in USA (08/09) ® SICO Incorporated.
Part No. 281610 Rev. C
BEFORE YOU BEGIN...
Read and understand these instructions
before operating.
Use caution and care for your back when
lifting, pushing, pulling, or folding and
unfolding these units. Never lift more than
you are able to safely handle.
TOOLS REQUIRED
- Two 17mm wrenches
If you have any problems during setup,
contact SICO Customer Care at
1-800-424-0796
WARNING
To avoid injury, read and understand
these instructions before you start to
set up the stage.

ASSEMBLY EXPLODED VIEW - 2 TIER
2
STEP HOOK, LH
(TECHLITE ONLY)
STEP HOOK, RH
(TECHLITE ONLY)

ASSEMBLY EXPLODED VIEW - 3 TIER
3
STEP HOOK, LH
(TECHLITE ONLY)
STEP HOOK, RH
(TECHLITE ONLY)

1. Place one side rail
vertically on a level work
surface.
2. Position one step ( ) as
shown beside the frame.
3. Insert one bolt ( ) through
frame to step, then place
washer and nut ( )
under the step to fasten it.
Caution: Do not tighten until
fully assembled.
13
6
16 23
ASSEMBLY INSTRUCTIONS
4
13
23 16
4. Position the second side
rail against this step. Use
same bolts, washers, and
nuts to fasten it.
5. Repeat 1-4 to install
remaining steps.

ASSEMBLY INSTRUCTIONS
5
6. Rotate the assembly step,
and set it on the floor.
7. Use bolt ( ) to install sway
brace ( ) on the back.
And fasten with washers
and nuts ( ).
8. When all 4 feet are resting
on the floor and sit level,
tighten all the bolts.
20
30
16 23
9. If you can’t reach the bolts
under the first tier, turn the
stairway over, as shown,
and tighten.
20