Siemens VNT-MP User manual

Siemens Building Technologies
Fire Safety
P/N 315-050489-0
INTRODUCTION The Model VNT-MP Mounting Plate from Siemens Building Technologies, Inc. is for
use in CAB1, CAB2 and CAB3 enclosures for mounting the VNT, VNT-PS, Ethernet
Multimode Fiber Switch module and XND modules. One VNT-MP can be installed in a
CAB1, CAB2 or CAB3 enclosure.
VNT-MP Mounting Plate is for indoor use only in dry environments.
INSTALLATION
Remove all system power before installation, first battery then AC. (To power up,
connect the AC first, then the battery.)
The VNT-MP mounts in the bottom row of a CAB1, CAB2 or CAB3 enclosure using
the four 10-32 screws provided.
1. Insert the four screws in the CAB1, CAB2 or CAB3 backbox in the positions
indicated by the the numbers “1” and “5” in Figure 1. Place the four holes
on the VNT-MP Mounting Plate over the screws. (Refer to Figure 2.)
2. Tighten the four screws to secure the mounting plate in place.
CAB3-BB
1
1
5
5
1
1
5
5
CAB2-BB
CAB1
1
1
5
5
Mounting Plate for the VNT
Installation Instructions
Model VNT-MP
Figure 1
VNT-MP Mounting Positions

Siemens Building Technologies, Inc.
8 Fernwood Road
Florham Park, New Jersey 07932
Siemens Building Technologies, Ltd.
2185 Derry Road West
Mississauga, Ontario L5N 7A6 Canada P/N 315-050489-0
CAB2
MOUNTS WITH
10-32 SCREWS
IN 4 PLACES
Figure 2
Installing VNT-MP Mounting Plate in CAB2 Enclosure
Install Jumpers Install the two jumpers (P/N 110-398369) included with the VNT on the terminal block
of the VNT-MP as shown in Figure 3.
INSTALL JUMPERS ON
TERMINAL BLOCK
AS SHOWN
Figure 3
Installing Jumpers on VNT-MP Terminal Block
COMPATIBILITY The VNT-MP can be used in CAB1, CAB2 and CAB3 enclosures.
SPECIFICATIONS VNT-MP Mounting Plate: 14.25”W x 14.25”H