Basic operation en
7
2. Slide your finger to the right over the settings range
until appears in the display.
aAfter approx. six minutes, the appliance automatic-
ally switches to a lower fan setting.
6.7 Switching off intensive mode, variant1
▶Press until the required fan setting is reached.
aIntensive mode is ended early.
6.8 Switching off intensive mode, variant2
▶Slide your finger to the left over the settings
range until the required fan setting is reached.
aIntensive mode is ended early.
6.9 Switching on the boost function
The boost function is a short-term maximum power set-
ting which can be activated in any fan setting.
▶Press .
aAfter approx. 20 seconds, the fan automatically
switches back to the fan setting that was previously
set.
6.10 Switching on the fan run-on, variant1
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶Press or slide in the filter pull-out.
aThe appliance switches off automatically after ap-
prox. 10 minutes.
6.11 Switching on the fan run-on, variant2
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶Slide in the filter pull-out.
aThe appliance switches off automatically after ap-
prox. 10 minutes.
6.12 Switching on automatic mode1
The optimum fan setting is set automatically using a
sensor.
▶Press .
6.13 Switching off automatic mode1
▶Press or .
aThe ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
aAutomatic mode runs for a maximum of four hours.
6.14 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶Press .
6.15 Setting the brightness
▶Press and hold until the required brightness is
reached.
6.16 Switching on the audible signal
▶Press and hold and at the same time for ap-
prox. threeseconds until a signal sounds.
6.17 Switching off the audible signal
▶Press and hold and at the same time for ap-
prox. threeseconds until a signal sounds.
6.18 Sensor control1
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡Factory setting:3
¡Lowest setting:1
¡Highest setting:5
6.19 Setting the sensor control1
Requirement:The appliance is switched off.
1. Press and hold for approx.four seconds until
the setting is displayed.
2. To change the setting, slide your finger over the set-
tings range .
3. To save the setting, press and hold for ap-
prox.fourseconds.
6.20 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡After the appliance has been switched off, ap-
pears in the display for the grease filter.
¡After the appliance has been switched off, ap-
pears in the display for the odour filter.
¡A signal sounds repeatedly.
▶Press .
aThe saturation indicator is reset.
6.21 Setting the saturation indicator,
variant1
The saturation indicator must be adjusted depending
on the filter used.
Requirement:The appliance is switched off.
1. To set circulating-air mode for the standard odour
filter, press and hold and until appears in
the display.
2. To set circulating-air mode for the CleanAir standard
odour filter or the CleanAir Plus odour filter, press
and hold and repeatedly until appears in
the display.
1Depending on the appliance specifications
