CONVERT 2/3
PITCHING INSTRUCTIONS
Congratulations on the purchase of your new Sierra Designs tent! In order to familiarize yourself with your new tent, we
recommend you“test pitch” it before embarking on your wilderness adventure.
PACKAGE INCLUDES: Tent body, rain fly, 3 poles, guy cords, V-stakes, storage bag, and pole bag with stake pocket.
STEP 1: Find an even piece of ground; be sure area is clear of
debris. Layout your tent as shown. Stake the 4 corners
and 2 center loops (circled).
STEP 2: Assemble hubbed poles. Locate the YELLOW pole ends and insert into
tent corners with YELLOW SD Anchors/webbing. Attach TIP CLIPS to
center pole tips. Make sure long center pole is on TOP.
Yellow Pole
Yellow webbing &
SD Anchor
Tip Clip
Center pole
must be on top.
STEP 3:
Assemble single yellow pole. Locate center of pole and clip it
into Hybrid Hub. Insert pole tips into yellow SD Anchor.
Hybrid Hub
Note: Must be installed
BELOW center pole.
Yellow Pole
Yellow webbing &
SD Anchor
STEP 4: Connect Split Clip and Tent Lite hooks to tent poles.
Split Clip
Tent Lite Hook
STEP 5: Lay the rain fly over the tent body matching the RED corner of the
tent with the RED corner on the fly. On the UNDER side of the fly,
attach Tip Clips at front and rear of tent then wrap the 10 velcro
loops around tent poles at guyout points. NOTE: this will ensure
proper fly tensioning.
VL
TC=Tip Clip
VL=Velcro Loop
STEP 6: Attach fly cord loop around pole tip at all stake out points.
Adjust tension by pulling down on String Lock cord
Pull down String Lock
cord to tighten
Attach fy cord loop around pole tip
VL
VL
TC VL
VL
VL
TC
STEP 1:
Congratulations on the purchase of your new Sierra Designs tent! In order to familiarize yourself with your new tent, we
recommend you“test pitch” it before embarking on your wilderness adventure.
CONVERT 2/3
STEP 2:
Yellow Pole
Tip Clip
Center pole
must be on top.
STEP 3: Assemble single yellow pole. Locate center of pole and clip it
into Hybrid Hub. Insert pole tips into yellow SD Anchor.
Hybrid Hub
Note: Must be installed
BELOW center pole.
Yellow Pole
STEP 4: Connect Split Clip and Tent Lite hooks to tent poles.
Tent Lite Hook
Split Clip
STEP 5:
VL=Velcro Loop
TC=Tip Clip
VL
VL
STEP 6:
PITCHING INSTRUCTIONS
Find an even piece of ground; be sure area is clear of
debris. Layout your tent as shown. Stake the 4 corners
and 2 center loops (circled).
Assemble hubbed poles. Locate the YELLOW pole ends and insert into
tent corners with YELLOW SD Anchors/webbing. Attach TIP CLIPS to
center pole tips. Make sure long center pole is on TOP.
PACKAGE INCLUDES: Tent body, rain fly, 3 poles, guy cords, V-stakes, storage bag, and pole bag with stake pocket.
Yellow webbing &
SD Anchor
Yellow webbing &
SD Anchor
Pull down String Lock
cord to tighten
Attach fly cord loop around pole tip
Attach fly cord loop around pole tip at all stake out points.
Adjust tension by pulling down on String Lock cord
Lay the rain fly over the tent body matching the RED corner of the
tent with the RED corner on the fly. On the UNDER side of the fly,
attach Tip Clips at front and rear of tent then wrap the 10 velcro
loops around tent poles at guyout points. NOTE: this will ensure
proper fly tensioning.
TC VL
VL
VL
TC
VL
