Sierra Designs Clip Flashlight 2 Configuration guide

SD PitchInst clip.pdf 1 6/13/16 12:40 PM
Clip Flashlight 2
PITCHING INSTRUCTIONS
Congratulations on the purchase of your new Sierra Designs tent! In order to familiarize yourself with your new tent, we recommend
you “test pitch” it before embarking on your wilderness adventure.
PACKAGE INCLUDES: Tent Body, Rain Fly, 2 Poles, 4 Guy Cords, 9 Hex Peg Stakes, 1 Pole bag with attached stake bag.
STEP 1: Find an even
piece of ground; be sure
the area is clear of
debris. Lay out your tent
as shown. Stake the 4
corners (circled).
STEP 2: Assemble poles.
Insert long pole into
SD Anchor at front of tent
and short pole into
SD Anchor at rear of tent.
STEP 3: Connect Tent Lite Hook to poles.
Tent Lite Hook
STEP 4: Lay the rain fly over the tent body matching RED corner of
the tent with the RED corner of the fly.
Match RED corner of fly with
RED corner of tent body
STEP 5: Connect the velcro loops on the underside of the fly
to the rear and front hoop poles. (6 total)
Velcro Loop
Long Pole
C
M
Y
CM
MY
CY
CMY
K
SD Anchor
Short Pole
SR Buckles
STEP 6: Attach fly cord loop around 4 pole tips. Adjust
tension by pulling down on String Lock cord. Clip SR
buckles at rear of tent and adjust tension.
Attach fly cord
loop around
pole tip
STEP 1: Find an even
piece of ground; be sure
the area is clear of
debris. Lay out your tent
as shown. Stake the 4
corners (circled).
STEP 2: Assemble poles.
Insert long pole into
SD Anchor at front of tent
and short pole into
SD Anchor at rear of tent.
Congratulations on the purchase of your new Sierra Designs tent! In order to familiarize yourself with your new tent, we recommend
you “test pitch” it before embarking on your wilderness adventure.
PACKAGE INCLUDES: Tent Body, Rain Fly, 2 Poles, 4 Guy Cords, 9 Hex Peg Stakes, 1 Pole bag with attached stake bag.
STEP 3: Connect Tent Lite Hook to poles.
STEP 5: Connect the velcro loops on the underside of the fly
to the rear and front hoop poles. (6 total)
Clip Flashlight 2
PITCHING INSTRUCTIONS
Tent Lite Hook
Long Pole
Velcro Loop
STEP 4: Lay the rain fly over the tent body matching RED corner of
the tent with the RED corner of the fly.
C
M
Y
CM
MY
CY
CMY
K
SD PitchInst clip.pdf 1 6/13/16 12:40 PM
SD Anchor
Short Pole
Match RED corner of fly with
RED corner of tent body
SR Buckles
STEP 6: Attach fly cord loop around 4 pole tips. Adjust
tension by pulling down on String Lock cord. Clip SR
buckles at rear of tent and adjust tension.
Attach fly cord
loop around
pole tip

SD PitchInst clip.pdf 2 6/13/16 12:40 PM
Clip Flashlight 2
USING YOUR TENT
C
M
Y
CM
MY
CY
CMY
K
GUYING OUT YOUR TENT: Your tent
includes guy out loops, guylines, and
stakes. It is good practice to always
guy out your tent, but is absolutely
necessary when it’s windy.
Use the black LINE-LOK to adjust the
length of the guy line.
Guy out your tent where shown below to prevent pole
rotation/breakage during high winds.
Stake out the end of the guy
line into the ground.
OPEN AWNING SETUP: The
vestibule panel on your tent can be
configured to provide awning
coverage in front of the door.
1. Tie guylines to yellow webbing
loops on vestibule panel corners.
2. Insert trekking pole tips through
yellow webbing loops.
3. Stake out guylines
USING YOUR TENT
STRING LOCKS: The corner points
of your tent feature String Locks
providing a range of stake out
options. Lift up on the tab to
decrease tension. Pull on the
knotted end to increase tension.
C
M
Y
CM
MY
CY
CMY
K