Profizelt24 PVC-Tent 6x12 m User manual

Aufbau-Anleitung
Assembly instruction
Instrukcja obslugi
Gebruiksaanwijzing
Instruction de service
PVC-Zelt 6 x 12 m
PVC-Tent 6 x 12 m
PVC-Namioty 6 x 12 m
PVC-Tent 6 x 12 m
Tente PVC 6 x 12 m
Eine Marke der TOOLPORT GmbH
TOOLPORT GmbH
Gutenbergring 1-5
22848 Norderstedt
Telefon 040 / 60 87 27 17
Telefax 040 / 60 87 27 37
E-Mail: [email protected]

Instruction manual PVC-tent 6 x 12 m
Introduction
To get the most out of your new pavilion, please read this manual and the safety instructions before
use. Please also save the instructions, as you may need to refer to them at a later date.
To guarantee a fluently mounting we recommend 6 people for building up the tent. Please ensure
that you have a free area of approx. 90 square meters for the mounting. The heaviest construction
part is the roof, which has a weight of 53,0 kgs.
Main components Technical data
1. Short poles (28 pcs) Tent poles: 1.10 mm steel tubing,
2. Long poles (48 pcs) 38 mm diameter
3. Shanks (14 pcs) Fabric: PVC, 500 g/m2
4. Cross-braces, female coupling (14 pcs.) Sides, height: 2.00 m
5. Cross-braces, male coupling (7 pcs.) Centre, height: 2.80 m
6. 3-way corners 110° (4 pcs)
7. 4-way corners 110° (10 pcs)
8. 3-way corners 140° (2 pcs)
9. 4-way corners 140° (5 pcs)
10. Straight cross-pieces (10 pcs)
11. Straight T-pieces (4 pcs.)
12. Roof (1 pce)
13. Side panels (12 pcs)
14. Door panels (2 pcs.)

A trademark of TOOLPORT GmbH
Intruction manual
Erection
Lay all poles, pieces and corners out on the ground as shown in the diagram. Insert poles into cor-
ners, cross-pieces and T-pieces.
Please assemble the stribes to the roof construction as shown below. Take care that the screws
point inwards to avoid damage of the roof fabric.

Lift one side of the roof structure and insert the legs (3). Pull the roof (12) over its supporting
structure and tie it securely in place. Lift the other side of the roof structure up and insert the remai-
ning shanks.
Hang the side panels.
The pavilion can be tied down with guy ropes or some other form of anchoring if required.
Warning
The wrong way is grasp only the leg fabric which is welded on the roof,
it is easy to rip the leg fabric off from the welding point of the main roof.
Please NEVER do it this way!
6x12 meter party-tent goundbar system
1. Pipe
No.2: 1940mm long pipes, 18pcs
2. Connector
B: Three way connector for side wall, 10pcs
C: Three way connector for door, 4pcs
A: Three way connector, 4pcs