Signature Hardware Glenwood 906537 User manual

GLENWOOD DECK MOUNT TUB FAUCET
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing fixtures. Signature
Hardware accepts no liability for any damage to the
faucet, plumbing, bathtub, floor, or for personal injury
during installation.
Observe all local plumbing and building codes.
Unpack and inspect the faucet for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-866-855-2284.
Ensure that you have gathered all the required
materials that are needed for the installation.
For these instructions, it is assumed that the old
faucet has been completely removed and any
necessary repairs or modifications to the water
supply have been completed.
TOOLS AND MATERIALS:
Plumbers
Tape
Thread
Sealant
Adjustable
Wrench
Phillips
Screwdriver
1Glenwood Deck Mount Tub Faucet Installation Instructions
Basin Wrench
SKU(s): 906537

GLENWOOD DECK MOUNT TUB FAUCET
INSTALLATION
3. From below, finish tightening the lock nuts to secure
the faucet to the tub. Use an adjustable wrench or
basin wrench to tighten firmly.
4. Attach the hand shower cradle to the outlet located
on the top of the faucet body, as shown. Apply plumb-
er’s tape or thread sealant to the threads before
tightening. Tighten firmly using an adjustable wrench.
1. Remove the lock nuts from each of the deck mount
couplers. Insert each coupler into its prepared mount-
ing hole and tighten the lock nuts from underneath
until hand-tight. Do not yet fully tighten.
2. Attach the faucet body to the installed deck mount
couplers. Position the faucet body so that it is
centered, then tighten the nuts using an adjustable
wrench.
Tip: Wrap the nuts with a soft cloth before using an
adjustable wrench to tighten, to avoid scratching the
decorative finish.
2Glenwood Deck Mount Tub Faucet Installation Instructions

GLENWOOD DECK MOUNT TUB FAUCET
7. Once installation is complete, turn the faucet on
for appoximately 60 seconds to check for any leaks.
Ensure that hot and cold water are running appropri-
ately. Divert water flow to the hand shower for testing
5. Use the flexible hose to connect the hand shower
to the outlet located on the hand shower cradle, as
shown. Tighten firmly.
6. To complete the installation. connect the water
supply lines (not included) to the faucet’s inlets. Apply
plumber’s tape or thread sealant to the threads
before tightening.
3Glenwood Deck Mount Tub Faucet Installation Instructions
60 sec