Sigtronics ST-11 User manual

igtronics
®
Sigtronics
®
S
…when it counts!
Sigtronics Corporation
178 East Arrow Highway
San Dimas, CA 91773
Phone: [phone]
E-mail: [e-mail]
Web Site: www.sigtronics.com
Model ST-11
Headset Instructions
The ST-11 series headset is adjusted at the factory for immediate use with all
Sigtronics emergency apparatus intercoms and radio adapters in emergency
vehicles. The headset is equipped with a single plug and a coiled cord.
The head strap is adjustable so you may custom t the headset. Place the headset
on your head and adjust the strap until minimum pressure is felt at the back of
your head.
The microphone boom is adjustable and is designed for use on the left side of
the head. Make sure you are speaking into the side of the microphone marked
with the arrow (see diagram) or substantial loss of gain will occur. Microphone
placement should be at the corner of the mouth, approximately ¼” from the lips.
Caution: Do Not immerse any part of the headset in water or any other liquid. Be
especially careful not to allow the microphone to become wet! Exposure to moisture
may cause internal corrosion and failure and will void your manufacturers warranty.
WINDSCREEN
The microphone windscreen will reduce annoying wind noise and breath pops
picked up by headset microphones. It also protects the microphone element
from dirt and moisture. The windscreen should be washed regularly to maintain
hygiene and avoid clogging. Wash in warm water and mild soap. Rinse thoroughly
and make sure it is completely dry before putting it back on.
To remove the windscreen, carefully grasp the windscreen lightly along its entire
length and remove from the microphone element being careful not to twist the
element itself.
Put the windscreen on the microphone by gently pulling from the open end. Do
not pull it so tightly that it stretches against the end of the microphone.
WARRANTY
Your headset is covered by a limited two-year parts and labor warranty. Please see
the enclosed warranty card for details.
You may refer to the parts list on the reverse side, if you choose to replace parts
yourself. The parts list describes parts for this particular headset only. Parts lists
for other models are available on our Web Site or can be obtained by contacting
Sigtronics Corporation.
TALK
Arrow
Microphone Boom
Windscreen
Microphone
10-12-2021 st-11.pdf

igtronics
®
Sigtronics
®
S
…when it counts!
Sigtronics Corporation
178 East Arrow Highway
San Dimas, CA 91773
Phone: [phone]
E-mail: [e-mail]
Web Site: www.sigtronics.com
Caution: Do Not immerse any part of the headset in water or any other liquid. Be
especially careful not to allow the microphone to become wet! Exposure to moisture
may cause internal corrosion and failure and will void your manufacturers warranty.
WINDSCREEN
The microphone windscreen will reduce annoying wind noise and breath pops
picked up by headset microphones. It also protects the microphone element
from dirt and moisture. The windscreen should be washed regularly to maintain
hygiene and avoid clogging. Wash in warm water and mild soap. Rinse thoroughly
and make sure it is completely dry before putting it back on.
To remove the windscreen, carefully grasp the windscreen lightly along its entire
length and remove from the microphone element being careful not to twist the
element itself.
Put the windscreen on the microphone by gently pulling from the open end. Do
not pull it so tightly that it stretches against the end of the microphone.
WARRANTY
Your headset is covered by a limited two-year parts and labor warranty. Please see
the enclosed warranty card for details.
You may refer to the parts list on the reverse side, if you choose to replace parts
yourself. The parts list describes parts for this particular headset only. Parts lists
for other models are available on our Web Site or can be obtained by contacting
Sigtronics Corporation.
Model ST-11
Headset Instructions
The ST-11 series headset is adjusted at the factory for immediate use with all
Sigtronics emergency apparatus intercoms and radio adapters in emergency
vehicles. The headset is equipped with a single plug and a coiled cord.
The head strap is adjustable so you may custom t the headset. Place the headset
on your head and adjust the strap until minimum pressure is felt at the back of
your head.
The microphone boom is adjustable and is designed for use on the left side of
the head. Make sure you are speaking into the side of the microphone marked
with the arrow (see diagram) or substantial loss of gain will occur. Microphone
placement should be at the corner of the mouth, approximately ¼” from the lips.
TALK
Arrow
Microphone Boom
Microphone
Windscreen
10-12-2021 st-11.pdf