SILESIA VELOX 2142 User manual
SILESIA VELOX
208 Frimley Road
Camberley
GU15 2QJ
INSTRUCTIONS
ADDENDUM and changes to the Velox Grill instructions for grills fitted
with digital timers and grills retrospectively fitted with
LCD TIMER - PARTNo: 2142.
TO
SILESIA GRILL MODELS T10 & T20
VELOX GRILL MODELS CG1 & CG2
DIGITAL TIMER INSTRUCTIONS:
The timer is pre-programmed with the following operating times:
1 = 30 seconds
2 = 45 seconds
3 = 1 minute
4 = 1 minute and 30 seconds
5 = 2 minutes
6 = 2 minutes and 30 seconds
7 = 4 minutes and 30 seconds
Timer selection:
The 7 adjustable pre-programmed operating times can be selected with the button. Each press will switch to
the next operating time – the corresponding LED is illuminated to indicate the time selected. Upon selection, the
new operating time is ready to be activated. This timer selection will remain the same until changed. The timer
selection is saved after power off, therefore, the last timer setting used will come on after return to power on.
Start the timer:
Select time with the button. Start the timer by pressing the button. The remaining time is counted down in
seconds. When the time has elapsed, the alarm will sound and the display will flash 00:00.
To modify pre-programmed operating times:
Select the operating time that you wish to change by using the button. Press and hold the button for one
second (the LED of the time selected will flash indicating that the time is ready to be modified). You now have 5
seconds to start modifying the time. While the LED is flashing press the or buttons to activate the
programming mode (indicated by the two flashing dots on the display) and immediately continue to press until the
required time is displayed. When the two dots on the display have stopped flashing, the new time has been stored.
Pause the timer:
If the button is pressed during the timing cycle, the sequence is interrupted and the display flashes. To
continue the timer cycle again, please press the button again.
Cancel the timer:
If the button is pressed for 3 seconds after start, the timer is cancelled and the display will flash 00:00 and
after releasing the button, the initial operation time is displayed.
Temporary settings:
Select the operating time that you wish to change by using the button. Press the or buttons to
activate the programming mode (indicated by the two flashing dots on the display) then immediately continue to
press until the required time is displayed. This time will remain until a new operating time is selected (or at power
off).
Stop the timer buzzer alarm sound:
After completion of the timer cycle the buzzer alarm sounds for 5 seconds and the display will flash 00:00.
If needed the alarm sound can be stopped during the 5 seconds by pressing the button.
Changing the duration of the buzzer alarm sound (P1):
Press the and the buttons simultaneously for 2 seconds, the display will change to P1.
Then press the button and the value of P1 is displayed (pre-programmed for 5 seconds). Press and
hold the button and press the or button until the required alarm sound time has been
reached.
The length of the alarm sound can be programmed between 0 and 60 seconds with 0 = no alarm. Wait
approximately 1 minute and the timer will store the new setting and exit the programming mode. Please
note:If at any time the display shows P2, P3, P4 or P19, simply press the button until the display
show P1.
00.30
1234567
DIGITAL DISPLAY
INCREASE TIME PROGRAMME
SELECT
PROGRAMME
BUTTON
START/STOP
CANCEL
TIMER PROGRAM INDICATOR LIGHTS
DECREASE TIME/
CANCEL ALARM
Silesia - Velox
208 Frimley Road
Camberley GU15 2QJ
Phone: 01276 681919
www. silesia.co.uk
Table of contents
