SILYNX C4OPS User manual

20M H20 DIVABLE CONFIG
Acoustic Tube for
Covert Monitoring
CONNECTING EARMUFFS
Helmet Clip
C4OPS
Control Box Peltor/ Sordin Headset Adaptor
P/N: CA0015-01
Earmuff
NOTE: Prior to diving, disconnect all
other radio adaptors and attach diving caps.
Tighten battery cover
Acoustic Tube
Helmet Clip
Headband
C4OPS Maritime Headset Cong
(P/N: SHS0003-17)
The C4OPS System congured with the C4OPS Maritime Headset Cong
(P/N: SHS0003-17) and MBITR 10 pin radio adaptor (P/N: CA0035-00) is
20m immersible.
CONFIGURATION NOTICE: This document contains operational informa-
tion related to the Silynx C4OPS® Headset. The information contained here-
in is for the operation and support of the C4OPS® Headset.
PROPRIETARY NOTICE: This document contains information that is pro-
prietary to Silynx Communications, Inc. It is furnished solely for operation
and support purposes and is not provided for reprocurement purposes. All
reprocurement and manufacturing rights are expressly reserved by Silynx
Communications, Inc. and no such use may be made of this document, either
directly or indirectly, without the prior written consent of an authorized ofcial
of Silynx Communications, Inc.
SILYNX COMMUNICATIONS, INC PUBLISHED AND CONFIDENTIALWORK
Fast Guide - DOC-USM000011 - Rev 06, April 2015ALL RIGHTS RESERVED COPYRIGHT:
www.silynxcom.com
1.866.325.1731 | [email protected]
9901 Belward Campus Drive Suite 150 Rockville, MD 20850
FAST GUIDE
MBITR 10 pin radio adaptor
(P/N: CA0035-00)
Micro C4OPS
External Battery
Compartment
(P/N: CA0234-00)
C4OPSMICRO
C4OPS
MBITR 10 pin
radio adaptor
(P/N: CA0035-00)
FAST GUIDE
C4OPS
PROTECTION FROM WITHIN

SETTING UP OPERATING C4OPS®BASIC FUNCTIONS
(+) Volume
(-) Volume
Secondary PTT
“Pairing Successful”
“Pairing Activated”
Beeps 30 sec
NOTE: If “Pairing Failed” repeat the steps above.
(-) Hear Thru
Low Sensitivity/
Hear Thru Off
(+) Hear Thru
High Sensitivity
(1) Press
& hold
(2) Press & hold
pairing keys 3 sec
PAIRING DUAL WIRELESS PTT [DWPTT]
HEAR THRU LEVEL VOLUME LEVEL
Off/ On/ Volume Level
High Sensitivity
Low Sensitivity/
Hear Thru Off
NOTE: In windy conditions
reduce “Hear Thru”
CHANNEL SELECTION VOICE PROMPT VOLUME LEVEL
EXTRAS
(2) Press & hold 3 sec
to conrm (2) (+) Volume
(2) (-) Volume
(2) Press & hold 3 sec
to conrm
(1) Press until you hear
“Channel Selection”
(1) Press until
you hear “Voice
Prompt Level”
Press & hold 3 sec “Extras”
In high noise, such as aircraft/vehicles,
you may hear whistling. Press (-) until
the sound disappears. If the problem
continues, reinsert the ear buds and
make sure you pass the sealing test.
TROUBLESHOOTING:
MOUNTING THE CONTROL BOX
Molle Clip
Zipties
Zipties
*1.5V AA Lithium battery
NOTE: No battery needed if using MBITR side connector.
Peltor/ Sordin
Headset Adaptor Maritime Headset Cong
Secondary
Radio Lead Connect
Intercom Cable Adaptor
Connect
Attach
Tighten
(1)
Connect
C4OPS Control Box
C4OPS In Ear Headset
Headband
Boom Mic Ops Core Chinstrap
Boom Mic
Basic In Ear Headset
(Blocked Connector)Hybrid Headset (Boom Mic Connector)
(2)
(6) (3)
(4)
(5)
Rotary Knob
Off/ On/ Volume Level
Primary PTT
Secondary PTT
PTT3 / Hot Key
(+)
(-)
Mode
C4OPS CONTROLS
EAR BUD LEAK TEST
INSERTING EAR BUDS
Shell Ear Retainers Keep mic exposed
Attach collar clip. Hang In Ear
Headset on your ear. Squash foam ear plug. Pull upper ear up and back and push the ear
bud rmly into the canal.
Press ear bud
until foam ear
plug expands.
Tighten nape slider. Position ear
retainer.
“Leak
Right”“Leak Left”
Leak = Reinsert ear plugs /
replace ear plug size.
OR
No = Pass
“C4OPS 2X Beep”
(1) Turn MBITR on.
Enable MBITR side
connector.
(2) Turn C4OPS on.
“Leak Both”
VP
VP
(3) MBITR is auto set
to external audio and
keypad locked.
(4) Ear plug sealing
test will begin.
(5)
Primary Radio Lead
GETTING STARTED
Primary PTT
VP = Voice Prompt = Important
*