SimplyRFiD Wave CS108 User manual

SimplyRFiD Wave Quick Start Guide
This guide provides simple steps
to let you quickly start using your
new Wave RFID handheld reader.
Please begin by checking the contents
of this box. It should include:
CS108 RFID Sled Handheld Reader
CS108B Battery
USB Type C to USB Type A cable
This guide
Next, install the battery in your
handheld:
1. To access the battery compartment,
remove the battery cover:
2. To insert the battery pack into the
battery compartment:
3. The battery should be fully secured
by the battery spring-loaded clip as
shown.
4. Replace the battery cover. Make
sure that the locking tabs at the front
of the battery cover are fully inserted
into the slots.
5. Fully rotate to close the metal
latches to secure the battery cover in
position.
Copyright 2022 SimplyRFiD
www.simplyrfid.com Quickstart Page 1 of 2

Once the battery is installed, it is
important to fully charge the unit before
using it the first time.
It takes approximately 4 hours to be fully
charged. Connect the supplied USB Type C
plug to CS108 and connect the Type A plug
into the included USB charger. The RED
charging LED will light. Charge the unit until
the red light goes out.
Now it’s time to configure your iPhone
1. First, scan this QR code using your
iPhone to download the Wave app:
Or you can search “SimplyRFiD” in
the app store to locate the Wave
Enterprise app.
2. Once the Wave app is installed, be
sure to enable Bluetooth by opening
the Settings app and switching
Bluetooth to On.
Note: Do not use the Bluetooth pairing
screen to connect the CS108 to your
iPhone, that step comes later.
3. To power on CS108, press and hold
the power button for 3 seconds and
then release, after that the GREEN
LED will light up continuously.
Finally, configure the Wave app
Tap on the Wave icon on your iPhone to
launch the app. The first time the app runs,
you will be prompted to connect to your
scanner. If the scanner is powered on it will
show up in the list of devices. Identify your
handheld by comparing the serial number of
your device to the number displayed on the
screen.
On the next screen you’ll be prompted to
check your email for a QR code. You’ll need
to use the CS108 handheld to scan this
code. Once the code is scanned the
handheld will be ready to use!
Copyright 2022 SimplyRFiD
www.simplyrfid.com Quickstart Page 2 of 2