SimplyRFiD Wave CS108 User manual

Wave
Quick Start Guide

This guide provides simple steps to
let you quickly start using your new
Wave RFID handheld reader.
Please begin by checking the contents of this box.
It should include:
CS108 RFID Sled Handheld Reader
CS108B Battery
USB Type C to USB Type A cable
This guide
Copyright 2022 SimplyRFiD
www.simplyrfid.com
WAVE

Install the battery in your handheld:
Step 1
To access the battery
compartment, remove the
battery cover:
Step 2
To insert the battery pack
into the battery
compartment:
Step 3
The battery should be fully secured
by the battery spring-loaded clip
as shown.
Step 4
Replace the battery cover. Make sure that the
locking tabs at the front of the battery cover are
fully inserted into the slots.
Step 5
Fully rotate to close the metal
latches to secure the battery cover
in position.
Copyright 2022 SimplyRFiD
www.simplyrfid.com

Once the battery is installed, it is important to fully charge the unit before using it the first time.
It takes approximately 4 hours to be fully charged. Connect the supplied USB Type C plug to CS108 and connect the Type A plug
into the included USB charger. The RED charging LED will light. Charge the unit until the red light goes out.
Now it’s time to configure your iPhone
Step 1
Finally, configure the Wave app
First, scan this QR code using your
iPhone to download the Wave app:
Step 2
Once the Wave app is installed, be sure to
enable Bluetooth by opening the Settings
app and switching Bluetooth to On.
Note: Do not use the Bluetooth pairing screen to
connect the CS108 to your iPhone, that step
comes later.
Step 3
To power on CS108, press and hold the
power button for 3 seconds and then
release, after that the GREEN LED will
light up continuously.
Or you can search “SimplyRFiD” in the app
store to locate the Wave Enterprise app.
Tap on the Wave icon on your iPhone to launch the app.
The first time the app runs, you will be prompted to connect to
your scanner. If the scanner is powered on it will show up in the
list of devices. Identify your handheld by comparing the serial
number of your device to the number displayed on the screen.
On the next screen you’ll be
prompted to check your email for
a QR code. You’ll need to use the
CS108 handheld to scan this code.
Once the code is scanned the
handheld will be ready to use!
Copyright 2022 SimplyRFiD
www.simplyrfid.com