Simulaids Economy Sani-Man Manual

Economy
Sani-Man
Directions for Assembly
Item Numbers 2144 & 2145

Body Head
Connect Pin
Inside Ear
Step1 Insert the pin into the ear and through the
neck then add the washer and connecting pin on
the inside of the head.
Step 2 Insert the push pins (2) into the back of
the manikin.
Step 3 Place enclosed rubber band over the push
pins. Step 4 Fold the bag lengthwise to facilitate
pushing the bag through the mouth. Tilt the
head back and place the closed end into the
tube in the mouth and push it through to the
back.
Lung
Face
Sheild

Step 5 Pull the sealed end of face shield bag
through leaving approximately 2” remaining
outisde of the mouth to allow using it for a face
shield.
Step 6 Flatten the sealed end of the face shield
against the manikin and secure it with the rubber
band.
Step 7 Spread open end of face shield bag over
nose and chin. Give finger sweep to open bag
properlysothattherearenotwistsintheairway.
Step 8 Place manikins in carry bag as shown.

POBox1289 - 16 Simulaids Drive
SaugertiesNY12477
Toll Free: (800)-431-4310 Fax: [phone]
www.simulaids.com 4/2006
Cleaning : Manikin Wash with warm, soapy water.
AED Pads: Apply Turtle Wax before placingAED pads, wash with warm soapy water
after removal.
Note: The manikin you have just purchased is a member of Simulaids’ Sani-Man line.
These manikins serve many individuals during a training session. In order to eliminate
cross-contamination, or the possibility of cross-contamination, these manikins are
designed with a “single use airway.” That means that only one person uses the plastic
bag airway system.
When the individual completes his/her airway inflations, the bag is to be removed and
the next student will place his/her airway in the manikin. The airway can be retained
by an individual for further use during that training session, but the airway should be
discarded at the end of that session. This is the only recommended procedure for elimi-
nating cross-contamination.
WARRANTY: Simulaids warrants this product to be free from any defect in materials and/or
workmanship for a period of three years from the date of purchase, as evidenced by the date of
invoice when the product was shipped to the end user. This warranty expressly does not cover
abuse, accidental or purposeful damage, or any form of modification to the product. Simulaids
reserves the right to either repair or replace affected parts or the entire unit, at their sole discre-
tion, after investigating and reviewing the actual product and the damage. In most instances, a
digital photo of the product in question showing the damage will help qualify a product for return
to the factory. At no time will any product be accepted at the plant without proper return authori-
zation issued by Simulaids.
Freight and Shipping charges are the sole responsibility of the end user. No product will be re-
ceived with shipping charges due. Any product considered for warranty work must be identified
by serial number and invoice number from the agency through whom the product was purchased.
Without this information the product will not receive a return authorization number as required.
RETURN POLICY: Should it be necessary to return an item for credit for any reason, contact
our Customer Service Department to obtain an RGANumber. Please refer to your invoice num-
ber when phoning in your request for returning merchandise. Should you have any questions or
wish further information on any product we manufacture call or write our Customer Service
Department.