3.3.2.2 Delete a program:
When executing the "delete a program" function, the programs menu is
acceded and the number of the first program in memory is blinking to point out
the deletion mode. Use key "SELECT" to select a program and key "ENTER" to
accede and confirm deletion of the selection. Use key "ESC" to unconfirm a
deletion and to leave the function. When leaving the function, the number of the
actual program on LCD screen cease to blink.
3.3.2.3 Select operating mode:
When executing the "select operating mode" function, which is available
only for the automatic units, the actual selection is blinking to point out the
acquisition mode. Use key "SELECT" to get through the operating modes, which
are automatic, semi-automatic and manual; the validation of the selected
operating mode is performed automatically. Use key "ESC" or "ENTER" to leave
the function and get back to the program menu.
3.3.3 Programs menu:
3.3.3.1 Program identification:
For a selected program, set the identification, using the numeric keyboard
characters chart;pressnumerickeyuntilthe desired characterisselected(4times
for the numeric value). Use key"ENTER" to validate the character and to validate
the characters string at the end(the new characters string is blinking). In a middle
of an acquisition, use key "ESC" to come backward and erase one or several
characters.
Example:EXAMPLE 1 keys 2, 2, ENTER E
(9 characters) keys 8, 8, 8, ENTER X
keys 1, ENTER A
keys 5, ENTER M
keys 6, ENTER P
keys 4, 4, 4, ENTER L
keys 2, 2, ENTER E
keys 9, 9, 9, ENTER space
keys 1, 1, 1, 1, ENTER 1
key ENTER to validate the characters string
3.3.3.2 Vacuum time setting (sensor disabled):
For a selected program set the vacuum time, in seconds; the validation is
automatically performed following the second digit entry (the new vacuum time is
blinking). In a middle of an acquisition, use key "ENTER" to validate the vacuum
time and key "ESC" to come backward and start over with a new acquisition (the
old vacuum time is blinking).
