SKS Germany COM/PAD User manual

GERMANY
5
6
6
2
1
1
T6
3
T6
max. 0,15Nm
4
Wärmequelle/Heat source
MANUAL ¬ COM/PAD ¬ 11756 ALLROAD ROAD MOUNTAIN
1.Prepare the COMPIT for the COM/PAD
All COMPIT versions (except COMPIT/ANYWHERE)
1. Loosen and remove the levelling screws on both sides
2. Remove the docking station
4. Insert the sealing ring again. Attach the connection plate with the cable and
4. secure it with screws. Do not exceed the 0.15 Nm tightening torque of the
screws.
5. Insert the docking station between the retaining clamps.
6. Insert the levelling screws and tighten them slightly. Adjust the angle of the
docking station. Tighten the levelling screws.
3-4. Loosen and remove the screws (T6). Remove and discard the dummy cover.
2.Connect the COMPIT to the e-bike
For e-bikes with a 12 V-36 V lighting system or power supply
Route the COMPIT connection cable to the motor, ensuring that the cable is
routedcleanlyalongthecableroutingspecictothebicyclemodel.
Connect the COMPIT connection cable to the cable of the lighting system with
waterproof terminals at a suitable point. Alternatively, solder connections can also
be used. Motor (connection cable is not supplied)

GERMANY
9V-36V 9V-36V
9V-36V 9V-36V
9V-36V 9V-36V
9V-36V 9V-36V
T6
max. 0,15Nm
MANUAL ¬ COM/PAD ¬ 11756 ALLROAD ROAD MOUNTAIN
BOSCH Gen. 2,3 und 4
Active Line/Performance Line/CX
Front light connection
Yamaha PB-X
Front light connection 12 V
BOSCH Gen. 4
Light connection or 12 V aux.
BAFANG M620
7015-BS-2 12V / 12W
Fazua
JST VSLE 03R connector / 12 V
Shimano / screw terminals
Light connection 12 V
Brose S
Front light connection 12 V
Panasonic
Light connection max. 36 V
3. Attach the COM/PAD
Place the COM/PAD on the COMPIT and turn it (about 45°) either to the right or left
above the docking station until you hear it click into place.
OPTIONAL!
Screw in the anti-theft lock screw as far as it will go.

GERMANY
ON OFF
USB C-PD OFF USB C-PD ON
ON/OFF
Touch 2 sec.
ON
Touch 2 sec.
MANUAL ¬ COM/PAD ¬ 11756 ALLROAD ROAD MOUNTAIN
4. Activate the COM/PAD
Switch on the e-bike
5. Charge the mobile device wirelessly
1 Switch on the COM/PAD. LED indicator lights up blue
2 Attach the mobile device and lock it by turning it
3MobiledeviceischargedandLEDindicatorashesblue.

GERMANY
OFF
Touch 2 sec.
USB C-PD ON
MANUAL ¬ COM/PAD ¬ 11756 ALLROAD ROAD MOUNTAIN
5 Charge the mobile device with cable
1 Switch on the COM/PAD USB C PD output. LED indicator is off!
2 Connect the cable (not supplied) to the COM/PAD.
3 Attach the mobile device and lock it by turning it
4 Connect the cable (not supplied) to the mobile device.
The mobile device is charging.