5All Rights Reserved. 2015 SkyVue®
Installation Manual - Tilt Mounts
For Masonry:
Set height, level, and mark drill locations on wall. With masonry bit, drill
1/2” pilot holes and hammer in lag bolt shields. Hold the plate to the wall.
Make sure the plate is level. Using the 4 supplied lag bolts and washers
secure plate to the wall.
For Wood:
Set height, level, and mark drill locations on wall.
IMPORTANT: Make sure that drill marks are located where bolts will get secured
in a stud or a substantial wood structure.
With wood bit, drill 3/16” pilot hole. Hold the plate to the wall. Make sure
the plate is level. Using the 4 supplied lag bolts and washers secure plate
to the wall.
For Anchoring Into
WoodMasonry
