Slingshot 2880658 User manual

APPLICATION
SLINGSHOT MODELS
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted
for in package. Please retain these installation instructions for future reference
and parts ordering information.
INSTALLATION VIDEO
There are three ways to access the installation video:
• Scan the QR Code with a mobile device.
• Click the QR Code if viewing the instruction as a PDF.
• Go to YouTube and search for SLINGSHOT TRAILER COVER INSTALLATION.
KIT CONTENTS
QUANTITY PART DESCRIPTION PART NUMBER
1Slingshot Full Vehicle Cover 2686253
1 Instructions 9961078
APPROXIMATE ASSEMBLY TIME
5–10 min
IMPORTANT
Your SLINGSHOT FULL VEHICLE COVER KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of
debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the
sequence shown.
Instr 9961078 Rev 03 0//2015 Page 1 of 3
P/N 2880658
FULL VEHICLE COVER KIT

Instr 9961078 Rev 03 03/04/2015 Page 2 of 3
INSTALLATION INSTRUCTIONS
1. Put vehicle in “REVERSE” and turn the key to
“OFF” position. Remove the key from the vehicle.
Apply the parking brake.
2. Drape the cover
1
over the vehicle. Note that the
SLINGSHOT logo will be on the hood of the
vehicle.
a. Begin by carefully fitting the cover over the
driver and passenger side mirrors.
b. Pull the cover over the front of the vehicle
hood.
c. Pull the cover over the rear of the vehicle. The
Fuel Door access panel on the cover should
match up with the fuel door on the vehicle.
TIP
This is intended to allow you to fuel the vehicle while it is
on a trailer without having to remove the cover.
3. For the two center straps: Attach the male buckle
of each center strap (A and B) to the female buckle
sewn to the cover as shown in figure. Feed the
webbing underneath the vehicle and connect each
of the matching buckles on the opposite side.
TIP
Loose the buckles on the strap (B) and toss the webbing
under the machine.
4. Pull the bottom edge of the cover down as far as
possible, all the way around the vehicle.
NOTE
Do not try to fit the cover over the license plate.
5. At the rear of the vehicle, open the zippered
pocket and attach the buckles (C) together. Pull
the webbing on each side, evenly, until the
webbing is snug as shown in figure. Do not tighten
the new strap, yet.
6. Along the entire perimeter of the cover
1
, pull the
fabric down to cover the tires (D) as much as
possible and remove all excess fabric and
wrinkles.
7. Tighten the webbing at the rear of the cover
1
to
take up any excess slack. Pull firmly, alternating
sides to keep the buckle on center, pull the buckle
out away from the machine to help set the
webbing. The webbing should be tight around the
base of the vehicle.

Instr 9961078 Rev 03 03/04/2015 Page 3 of 3
8. If necessary, re-tension the center straps.
9. The fuel door cover access panel allows access to
the fuel door.
WARNING
Ensure the cover is adequately tensioned prior to trailering the vehicle.
Remove any accessories that interfere with the cover and its ability to cinch down around the base of the tires.
Inspect that there are no sharp objects that will push against the cover.
Never trailer the covered vehicle while traveling in excess of the speed limit.
Do not over tension the cover.
Only trailer the vehicle with the cover installed facing forward.