Smart Solar AquaNura LP User manual

1
AquaNura LP Solar Birdbath Kit
0°C /32°F


Configuration and Assembly
We recommend the water be regularly topped off and changed to ensure it remains
clean and free from debris. Shallow birdbaths require more frequent filling due to
evaporation or the pump will run dry, which may cause damage
Frost causes damage and is not covered by warranty. Empty water and store
product inside during cold weather. For safety, we recommend doing this when the
weather is going to dip below 40°F.
Unit includes:
Solar panel housing x 1
Pump x 1
Fountain head set x 1
Extension Tube x 1
The AquaNura LP functions much like our original larger AquaNura but is designer to fit into
smaller, shallow birdbaths. This unit can still be used in a large deeper birdbath and there
will simply be more water sitting on top of the solar panel. We have included a 1” extension
tube for use in deep birdbaths to elevate the fountain heads above water.
In strong sunlight in a small birdbath or
during windy conditions, the pinhole
fountain head shown may cause water to
spray outside of the birdbath. Only use
this fountain head in the right conditions to
ensure your birdbath does not lose water.
* Birdbath not included
Warning! Important! Read Me!
Pump
1” Extension tube
Fountain head set
Pinhole Bubbler


2
Fill your birdbath with water and place
the AquaNura into the birdbath.
Attach the fountain head of your choice.
Important
!
BEFORE USE: Ensure that the connections are
water tight. Push the plugs together until they
touch the rubber o-ring, slide the threaded cap
over the plug and turn the cap until tight.
1
2
3



Position
Position your AquaNura so that
it receives direct sunlight. The
fountain will NOT work if the solar
panel is in a shaded area.

3
Performance
This product is designed primarily to operate in summer months but will also work in spring and
autumn provided there is strong direct sunlight. Performance is directly related to the amount and
strength of sunlight received. The Pinhole fountain head will work effectively in strong direct
sunlight but may need to be removed if there is excessive splashing in small birdbaths.
The Bubbler fountain head is preferred for strong sun and/or windy conditions.
Pump Cleaning / Manual Pump Start
Filter cover can simply be
pulled apart as shown.
Using the tab on the side of
the impeller cover, pull off the
impeller cover. You may use
a flat edge screwdriver to
gently pop the cover off
Remove filter
material and rinse
in water.
Remove the impeller by pulling
out of the pump housing using
your fingers or a pair of needle
nose pliers. Rinse all parts
thoroughly in water.
If the pump is not working immediately, try the following for a
manual start. Remove the pump cover. Remove the impeller
cover, face the panel to the sun, and start manually spinning the
impeller clockwise, this can take 1-3 minutes.
  


In bright direct sunlight your pump will work well
with a consistent fountain height and flow rate.
In slightly cloudy conditions your pump will
work however fountain height and flow will
vary as clouds pass in front of the sun.
In overcast conditions the solar panel does not
generate enough power to run the pump and it
will NOT work.
At night the solar panel does not generate
power and your pump will NOT work.

4© 2020.0
Smart Living Home & Garden warranties your solar panel, pump and battery (for Solar-on-Demand units) for one
(1) year from the original date of purchase from authorized distributors and retailers. The warranty covers parts
that are properly installed and regularly maintained. If the product fails due to a defect in material or
workmanship, Smart Living will replace the defective parts free of charge. Your fountain is designed for outdoor
use and with proper care will last for many years. If over time your fountain develops scratches or minor wear
from normal use, you can contact our customer service department for easy to apply one step touch up paint.
Please unpack and inspect the entire product upon receipt. Report any broken or missing pieces within five (5)
business days of receipt to our customer service department and we will provide replacement parts free of
charge. Please do not discard any damaged parts until instructed to do so by our customer service department.
Thank you for purchasing this Smart Solar fountain.
Register your Product Here:
https://smartlivinghg.com/wp/customer-service/product-registration/
FAQs are available online along with step by step video tutorials to help you with pump
cleaning and solar kit assembly.
Visit: https://smartlivinghg.com/wp/customer-service/faq/
Smart Solar is a Smart Living Home & Garden brand
Telephone: + 1 813 343 5775
Email: [email protected]
Web: www.smartlivinghg.com
US Patent 7484671, EU Patent 1648620
Maintenance
L
To maintain optimum performance, regularly clean
the solar panel using water or glass cleaner with a
non-abrasive sponge or cloth.
If the fountain head, nozzle, or tubes become
blocked, rinse through with water.
•Ensure the cables from the pump to the solar panel are connected properly.
•Ensure the pump tube is connected to the underside of the solar panel.
•Check water level in birdbath to ensure pump is fully submerged.
•Remove and clean impeller from the pump (see pump cleaning section).
•If dirty, clean glass on solar panel housing. Remove any hard water scale/build up.
•Try Manual Pump Start (see pump cleaning section).
•There may be an air bubble in the tube. Try pouring water down the tube to force out the
air bubble.
Troubleshooting Tips