Smart Sbx800 cat5-xt User manual

SMART Technologies ULC

20-01246-XX

SBX800 CAT5-XT

VVVQYDDDBXXXX

*VVVQYDDDBXXXX *

Caution

50'/15.2m Max. Cable Length

This Is Not a Network Connection

SBX800 CAT5-XT

≤ 50' (15.25 m)

Limited Equipment Warranty

Thank you for your recen t purchase. In the unlikely event that you have problems with your equipment, SMART’s technical support personnel

are available to assist you. The terms and conditions of SMART’s warranty are set forth below – please review them carefully. Please see the

reverse side of this page for warranty-claim procedures.

Limited Warranty to End-User Purchaser

Subject to the exceptions noted below, this limited warranty (the “Warranty”) covers all defects in materials and workmanship of your new

SMART hardware product, together with included software distribution media, pens, eraser and cables (the “Equipment”). SMART extends the

Warranty to the end-user purchaser (the “Purchaser”) of the Equipment.

The duration of the Warranty (the “Warranty Period”), commencing on the date of new purchase, is TWO YEARS for optional

accessories (including room control modules, wireless serial or USB connections, floor stands, speakers, cables, USB adapters,

keyboards, etc.) and service repair parts, with the following exceptions:

 Fully discharged SMART Slate™ lithium ion batteries are not covered by warranty.

 Projector lamps (used under normal projector operating conditions, not in excess of 8 hours per day and 260 days per year) are

covered by warranty for 500 hours or 90 days, whichever comes first.

THE WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT

LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND F ITNESS FOR A PARTICULAR P URPOSE. ANY REPRESEN TATION

OR WARRANTY, OR AFFIRMATION OF FACT, MADE BY ANY SALES REPRESENTATIVE OR OT HER AGENT OF SMART, INCLUDING

BUT NOT LIMITED TO STATE MENTS REGARDING CAPACITY, SUITABILITY FOR USE OR PERFOR MANCE, EXPRESS OR IM PLIED,

WHICH IS NOT SPECIFICALLY SET FORTH HEREIN WILL NOT BE BINDING UPON SMART.

SMART has not authorized any other party to alter, modify, extend, enhance or limit the Warranty and SMART will not assume any

responsibility or liability for any statements or representations made by any other persons or entities.

Repair or Replace

The Purchaser’s ex clusive remedy and SMA RT’s sole obligation during the Warranty Period shall be for SMART to repair or, at its option,

replace the Equipment that has failed or that has proven to be defective at no cost to the Purchaser except for the one-way shipping cost of the

Equipment to a SMART-authorized service center. Any charges associated with a rush-requested order, such as air express, are the

responsibility of the Purchaser. Prior to returning any equipment under the Warranty, the Purchaser must render proof of the original

purchase date and must thereafter obtain from SMART a Return of Merchandise Authorization (RMA) number. The RMA number shall

be clearly marked on the packaging of the Equipment being returned. All returned Equipment that is replaced under the Warranty shall become

the property of SMART.

Limitation of Damages

The liability of SMART to the Purchaser arising out of the purchase and supply of the Equipment or its use, whether based upon Warranty,

contract, tort (including, without limitation, negligence) or otherwise, shall not in any case exceed the original cost to the Purchaser of the

Equipment, and upon expiration of the Warranty Period such liability will terminate.

SMART shall not be liable, whether in contract or on any other basis, for any damages sustained by the Purchaser or any other person arising

from or related to loss of use, failure or interruption in the operation of the Equipment, delay in repair or replacement or for incidental,

consequential, indirect or special damages or liabilities, loss of revenue, loss of business or other financial loss arising out of or in connection

with the sale, lease, maintenance, use, performance failure or interruption of the Equipment.

Warranty Exclusions

The Warranty will not apply to and SMART will not be liab le for (i) any Equipment which is not purchased from an authorized SMART dealer or

distributor; (ii) Equipment that has been damaged by accident, abuse, neglect, misuse or causes other than ordinary use (see manuals that

ship with Equipment for further detail), including the direct application of any cleaning liquids, substances or abrasives to the hardware or onto

any display surface other than in accordance with the cleaning and care instructions included in the User’s Guide for the Equipment; (iii)

Equipment which has been altered, changed, serviced or repaired by anyone other than SMART-authorized repair personnel; or (iv) any

Equipment on which the serial number has been defaced, modified or removed. Warranty service hereunder shall not operate to extend the

original Warranty Period. T he Warranty excludes damage incurred in shipment to or from SMART. If the Equipment is received by the

Purchaser in a damaged condition, the carrier and SMART must be notified immediately. Purchasers located outside the U.S. or Canada

should instead contact the carrier and their SMART dealer or distributor.

Third-Party Equipment Warranty Extension and Exception

For equipment sold by SMART to the Purchaser but manufactured by a corporation other than SMART (such as wall-mounted cabinets,

carrying cases and other specified components), SMART shall extend to the Purchaser, to the extent permitted, any and all applicable warranty

provisions provided to SMART by the third-party manufacturer. The extension of any and all applicable third-party manufacturer warranty

provisions shall be an exception to this Warranty and represents SMART’s sole responsibility with respect to such equipment.

2 99-01039-20 A0

SMART Technologies ULC

20-01246-XX

SBX800 CAT5-XT

VVVQYDDDBXXXX

*VVVQYDDDBXXXX *

Caution

50'/15.2m Max. Cable Length

This Is Not a Network Connection

3 4

99-01039-20 A0 3

www.smarttech.com/kb/147499

www.smarttech.com/support www.smarttech.com/contactsupport

Support +1.403.228.5940 or Toll Free 1.866.518.6791 (U.S./Canada)

99-01039-20 A0

*99-01039-20-A0*

Hardware Environmental Compliance

SMART Technologies supports global efforts to ensure that electronic equipment is manufactured, sold and disposed of in a safe and environmentally friendly manner.

Waste Electrical and Electronic Equipment Regulations (WEEE Directive)

Waste Electrical and Electronic Equipment regulations apply to all electrical and electronic equipment sold within the European Union. When you dispose of

any electrical or electronic equipment, including SMART Technologies products, we strongly encourage you to properly recycle the electronic product when it

has reached end of its life. If you require further information, lease contact your reseller or SMART Technologies for information on which recycling agency

to contact.

Restriction of Certain Hazardous Substances (RoHS Directive)

This product meets the requirements of the European Union’s Restriction of Certain Hazardous Substances (RoHS) Directive 2002/95/EC. Consequently, this product also

complies with other regulations that have arisen in various geographical areas, and that reference the European Union’s RoHS directive.

Packaging

Many countries have regulations restricting the use of certain heavy metals in product packaging. The packaging used by SMART Technologies to ship products complies with

packaging laws.

China’s Electronic Information Products Regulations

China regulates products that are classied as EIP (Electronic Information Products). SMART Technologies products fall under this classication and meet the requirements

for China’s EIP regulations.

U.S. Consumer Product Safety Improvement Act

The United States has enacted the Consumer Product Safety Improvement Act which limits the lead (Pb) content in products. SMART Technologies is committed to complying

with this initiative.

FCC Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense.

trademarks of SMART Technologies ULC in the U.S. and/or other countries. All third-party product and company names may be trademarks

of their respective owners. Contents are subject to change without notice. 07/2010.

Environmental Protection Use Period for China

Table of contents

Other SMART Extender manuals