SmartRG SE80ac User manual

SE80
Quick Start Guide

Details
To minimize unwanted AC line noise that may degrade the performance of your SE80, take
advantage of the filtered outlet on the unit for powering your AC devices - especially USB
and other cell phone chargers, dimmer-capable lamps, plasma TVs and other devices
employing switching power supplies. Plug a power strip into the SE80 for additional filtered
capacity.
The bottom of the unit has a reset button and a gigabit Ethernet port.

Installing your SE80ac
Connect one end of an Ethernet cable into the Ethernet port
of the SE80ac and the other end to a LAN port on a SmartOS
router.
Plug the SE80ac into a nearby electrical outlet.
The LED flashes red. Wait for the LED to flash white. This pro-
cess may take about 2 minutes.
Once the LEDstays white, you can unplug the SE80ac and move
it to the location where you want it.
The LEDs repeat the colors and flashing. When the light glows
solid white again, connection is accomplished and you can log
into your network.
3

FCC Interference Statement
This device complies with Part 15 of the Federal Communication Commission Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment and receiver.
lConnect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
lConsult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or trans-
mitter.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with greater than 20cm between the radiator & your
body.
Industry Canada statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two con-
ditions: (1) This device may not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de
brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage
susceptible de provoquer un fonctionnement indésirable.
5

Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
(iii) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to
remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be
clearly indicated.
Avertissement:
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une util-
isation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux;
(iii) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de l’antenne et
les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au
masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués.
Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with greater than 20cm between the radiator & your
body.

Déclaration d'exposition aux radiations
Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environ-
nement non contrôlé. Cet équipement doit être installé et utilisé à plus de 20cm entre le radiateur et
votre corps.
7