Smeg A42C-2 User manual

Contents
1. INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 31
2. INSTALLATION OF THE APPLIANCE ______________________________ 33
3. DESCRIPTION OF CONTROLS___________________________________ 36
4. USE OF THE COOKING HOB ____________________________________ 43
5. USE OF THE OVENS ___________________________________________ 45
6. AVAILABLE ACCESSORIES _____________________________________ 46
7. COOKING HINTS ______________________________________________ 47
8. CLEANING AND MAINTENANCE _________________________________ 52
9. EXTRAORDINARY MAINTENANCE _______________________________ 55
THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES WHOSE
IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL.
INSTRUCTIONS FOR THE INSTALLER: these are intended for the
qualified technician who must install the appliance, set it functioning
and carry out an inspection test.
INSTRUCTIONS FOR THE USER: these contain user advice,
description of the commands and the correct procedures for cleaning
and maintenance of the appliance.
@
Further information about the products can be found at www.smeg.com
30

Introduction
1. INSTRUCTIONS FOR SAFE AND PROPER USE
THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND
THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE
PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE
READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE
USING THE COOKER. INSTALLATION MUST BE CARRIED OUT BY
QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN
FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND
CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS
BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND
HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED IMPROPER.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER
USE.
DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE
THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST
SPECIAL GARBAGE COLLECTION CENTRE.
IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED
ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES.
THE PLUG TO BE CONNECTED TO THE POWER CABLE AND THE SOCKET
MUST BE THE SAME TYPE AND MUST CONFORM TO CURRENT
REGULATIONS.
THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN
BUILT IN.
NEVER UNPLUG BY PULLING ON THE CABLE.
IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION
TEST OF THE APPLIANCE, FOLLOWING THE INSTRUCTIONS BELOW.
SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE
SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.
NEVER ATTEMPT TO REPAIR THE APPLIANCE.
ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE POSITION
(OFF) WHEN YOU FINISH USING THE HOB.
NEVER PUT INFLAMMABLE OBJECTS INTO AN OVEN: IF THEY CATCH FIRE
THEY COULD CAUSE A FIRE IN THE HOME.
31

Introduction
THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND
BRAND NAME IS VISIBLY POSITIONED ON THE REAR PROTECTIVE COVER
OF THE APPLIANCE. A COPY OF THE PLATE IS INCLUDED WITH THE
HANDBOOK AND YOU ARE ADVISED TO FIX IT IN THE APPROPRIATE
SPACE ON THE INSIDE COVER PAGE.
THE PLATE MUST NEVER BE REMOVED.
DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO
TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.
DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS
ON THE COOKING HOB GRIDS.
DO NOT INSTALL THIS APPLIANCE ON A RAISED PLATFORM
ATTENTION: IN CASE OF A CRACK BEING DETECTED IN THE GLAZED
CERAMIC HOB, IMMEDIATELY DISCONNECT FROM MAINS AND CONTACT
THE NEAREST SERVICING CENTRE.
THE APPLIANCE IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW
CHILDREN TO GO NEAR OR PLAY WITH IT.
WHILE COOKING WITH THE OVEN DOOR OPEN, A GREAT DEAL OF HEAT
WILL COME OUT: KEEP CHILDREN AWAY FROM THE OVEN.
THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE
2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE).
THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF
RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC
EQUIPMENT.
BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND
PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance or by the use of non-original
spares.
32

Instructions for the installer
2. INSTALLATION OF THE APPLIANCE
This unit is equipped with a type Y fire protection, and may be set
against walls that are higher than the hob.
Built-in appliance Free-standing installation
2.1 Electrical connection
Check that the voltage and dimensioning of the supply line correspond to
the characteristics shown on the plate fixed to the rear protective cover
of the appliance.
This plate must never be removed.
On the power line, install an omnipolar cut-off device with contact cut-off
distance greater than or equal to 3 mm, located in an easily accessible
position near the unit.
33

Instructions for the installer
34
The appliance is fitted with a terminal board at the rear for electrical
connections (see following diagram). To access, remove the rear cover.
For operation on 380-415V3N ∼ :use an
H05RR-F-type five-core cable (5 x 2.5 mm2).
For operation on 380-415V2N ∼ :use an
H05RR-F-type four-core cable (4 x 4 mm2).
For operation on 220-240V ∼ :use an
H05RR-F-type three-core cable (3 x 6 mm2).
The cable end to be connected to the
appliance must be provided with an ground
wire (yellow-green) at least 20 mm longer.

Instructions for the installer
Complete wiring up to power supply with an appropriately rated five-core
plug (see data plate) or, in case of operation from a 220-240V∼power
supply, with a three-core plug. Make sure that plug and wall socket are of
the same type and are in conformity with regulations in force. Make sure
that the appliance is properly earthed. Before powering, check that the
power line is properly earthed. Avoid using adapters or shunters.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
2.2 Positioning and levelling of the appliance
Having carried out the electricity hook-up, level the appliance using the
four adjustable legs.
2.3 Instruction for wall fixing (only on some models)
1) Fix the screw to the wall and hook the chain (B);
2) Hook the chain to the hole positioned at the rear of the cooker by
the gas pipe (A);
3) Once the chain is in position, push the cooker against the wall;
4) The height of the screw hole from floor level must not exceed 800
mm (C).
A
B
C
35

Instructions for the user
36
3. DESCRIPTION OF CONTROLS
3.1 Front control panel
All the cooker controls and commands are on the front panel.
The user has only to press the central key for 1/2 seconds to enable
use of the oven on first use or after a power blackout. (only for the main
oven)
DESCRIPTION OF SYMBOLS
FRONT LEFT-HAND
COOKING ZONE
MAIN OVEN
REAR LEFT-HAND
COOKING ZONE
AUXILIARY OVEN
GRILL
REAR RIGHT-HAND
COOKING ZONE
AUXILIARY OVEN
VARIABLE GRILL
FRONT RIGHT-HAND
COOKING ZONE
COOKING HOB CONTROL KNOB
Standard heating
The circle next to each knob indicates the cooking
zone it controls. To heat, push and turn the knob to the
desired position (1 to 9). Adjustment is continuous so
that the appliance also operates at any intermediate
value. To turn off, return the knob to 0.

Instructions for the user
Double heating
The circle next to each knob
indicates the cooking zone it
controls. To heat the inner cooking
zone, push and turn the knob to the
desired position (1 to 9).
To heat both the inner and outer cooking zones, turn the knob to or
; and then release. The knob will thus return to 9. To adjust heating
intensity, rotate the knob anticlockwise to the desired position. To return
to heating of the inner cooking zone only, set the knob back to 0 and then
turn to the desired position (1to 9). To switch off, return knob to 0.
MAIN OVEN THERMOSTAT KNOB
Selection of cooking temperature is carried out by
turning the knob clockwise to the required
temperature, between 50° and 250°C.
The tell-tale light comes on to indicate that the
oven is Warming up. When it goes out it means
that the required temperature has been reached..
Intermittent going on and off of the light means that oven temperature is
being constantly maintained at the programmed level.
The oven is switched on by turning the knob clockwise to any one of the
following functions:
NO FUNCTION SET GRILL ELEMENT (SPIT)
VENTILATED HEATING
ELEMENT + VENTILATION
50 ÷250°C
DEFROSTING
(NO HEATING ELEMENT
ENGAGED)
GRILL ELEMENT +
VENTILATION (SPIT)
37

Instructions for the user
38
AUXILIARY OVEN THERMOSTAT KNOB
Selection of cooking temperature is carried
out by turning the knob clockwise to the
required temperature, between 50° and
250°C.
The tell-tale light comes on to indicate that
the oven is warming up. When it goes out it
means that the required temperature has
been reached. Intermittent going on and off
of the light means that oven temperature is
being constantly maintained at the
programmed level.
The oven is switched on by turning the knob clockwise to any one of the
following functions except the oven light:
NO FUNCTION SET GRILL ELEMENT
UPPER AND LOWER
HEATING ELEMENT
UPPER HEATING ELEMENT +
GRILL ELEMENT
LOWER HEATING
ELEMENT
AUXILIARY OVEN VARIABLE GRILL
KNOB
Position the auxiliary oven thermostat knob
on the symbol or .
Turn the variable grill knob clockwise to the
desired
position.
When the signal light comes on the grill is
engaged.

Instructions for the user
3.2 Electronic Analogue Clock
The instructions provided apply to the main oven only.
LIST OF FUNCTIONS
MINUTE-MINDER BUTTON
AUTOMATIC SWITCH-OFF TIMING BUTTON
TIME SETTING AND RESET
VALUE DECREASE BUTTON
VALUE INCREASE BUTTON
3.2.1 Setting the time
When the oven is used for the first time, or after a power blackout, the
display flashes on and off at regular intervals. Press the key for 1/2
seconds to stop the display flashing and start setting of the current time.
Press the value modification keys or to increase or decrease by
one minute for each time a key is pressed.
Press one of the two value modification keys until the current time
appears. The clock will start from the time set 6/7 seconds after the last
key is pressed.
At the end of each programmed cooking operation, the clock gives 8
beeps, repeated 3/4 times at intervals of about 1 and a half minutes.
The beeps can be stopped at any moment by pressing any key.
39