Snom M-SC Series User manual

1.
2.
3.
4.
5.
How to Register a M15-SC to the M200-SC
Introduction
To use the Snom DECT M-SC series handsets, you need to register them on a DECT base. In the following we will show you how to register the M15-SC
handsets on the M200-SC base.
Step by step instructions
Place the handset (M15-SC) in its charging cradle for at least a few seconds. It is best to pair fully charged handsets. It is often possible to pair
the handsets without this first step, but since the handsets that are not paired very quickly switch to a power saving mode in which pairing is
impossible, it makes sense to get the handsets out of this mode by placing them in the charging cradle.
Take the out of the charging cradle.M15-SC
Press or on the handset. The appearsMain Menu
Press to scroll to and press or .User settings
Please note that even though the process is quite simple, it is necessary to follow the procedure carefully in order to achieve success quickly.

5.
6.
7.
8.
Press , to scroll to and pressRegistration or .
On the , press the silver on the front of the base . Both LEDs on the base will immediately startM200-SC base paging button for 4 seconds
flashing in sync. The base is now in register mode.
Press on the handset and then press the hash key (#).NEXT
If pairing was successful, a confirmation tone will sound from the handset and the word " " will appear on the display. The LEDs on theRegistered
base stop flashing.

Related articles
DECT MSC-Series How-to
Determining the IP address of your DECT M-SC-Series base
Entering Web Interface - WUI of your Snom DECT-M-SC Series Base
How to configure VPN on a M200SC - M215SC
How to factory reset the M200-SC , M215-SC
How to migrate LDAP settings from a deskphone to M215 SC or M200 SC
How to Register a M15-SC to the M200-SC
Setting up a Snom DECT Base of the M-SC-Series on a FritzBox
(you will be prompted to enter the pin code instead), place it in the charging cradle for a few seconds. ThenIf the registration failed
take it out and repeat the registration from step 1.
To take the base out of register mode, press the paging key once briefly.
Further Information
VoIP Essentials
Visit the Snom Forum
Open a support ticket
Find a local partner