Soitec COH-CEN-9-26FW User manual

COH-CEN-9-26FW
90mA
9W
50/60Hz
50
100-240VAC
185mA
18W
50/60Hz
50
100-240VAC
Remove from package. Remove four screws from
the outer cover ring and remove outer cover from
the base.
Cut grommet to suit the outside diameter of the
input power cord.
2 3
WARNING：
-THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE;WHEN THE LIGHT SOURCE REACHES
ITS END OF LIFE, THE WHOLE LUMINAIRE SHALL BE REPLACED.
-THE LIGHT SOURCE CONTAINED IN THIS LUMINAIRE SHALL ONLY BE REPLACED BY THE
MANUFACTURER OR HIS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON.
-THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN.
-THE POWER SUPPLY MUST BE TURNED OFF BEFORE INSTALLATION.
-NO WARRANTY WILL BE ACCEPTED IF THIS PRODUCT IS NOT INSTALLED BY A QUALIFIED
ELECTRICIAN.
-AC INPUT WIRE SPECIFICATIONS: 1.5MM2
-THE DRIVER CAN’T BE REPLACED AND IS SUITABLE FOR OPERATION WITH LED MODULES ONLY.
DIAMOND CENTOR LED Bunker Installation Guide
IP65
1.Disconnect mains supply before
installation or removing cover.
COH-CEN-18-35FB
Net Weight 1.28KG 2.03KG

CEOTIS ECLAIRAGE
C/O SOITEC
Parc technologique des fontaines
Chemin des Franques
38190 Bernin France
Email:[email protected]
TEL: [phone]
A. Drill four holes in the ceiling, in line with holes
in the base.
Ensure cables are clamped and held securely. Fix outer cover to base by tightening the four
screws.
Turn on the main power supply.
4 5
6
8
7
Loose two screws ,then individually connect the Live
wire and Neutral wire of AC input wire to L/N
terminal of Driver and tighten the screws.
32±2 6±2
Outer insulation
Inner insulation
B. Place cable through
grommet.
C. Screw the base to
ceiling surface and
make sure gaskets
are tted to
screws.
B
A
Fix the Earth wire of input wire to “ ” in the base.