SOMFY Solar Pack User manual

www.somfy.com
Ref : 5066778A
Solar Pack
EN - Installation instructions

Contents
1. Introduction
2. Safety
2.1 Safety and Responsibility
2.2 Speci c Safety Advice
3. Installation
3.1 Determine Location of Solar Panel
3.2 Mounting the Solar Panel
3.2.1 Glass Mounting
3.3 Battery State of Charge
3.3.1 Battery Preparation
3.4 Battery Tube Install Location
1. Introduction
The Solar Pack is a group of components that work in unison as a long life energy source for Somfy 12 Volt WireFree™ motors.
This Product is designed for indoor use only.
Contents of the Pack include:
(1) Solar Panel in Bezel
(1) Battery Tube with NiMH Battery Installed
(1) Wire Harness
(1) Glass-Mount Adhesive
(1) Alcohol wipe
(1) Instructions
Note: This product is designed to meet the energy requirements of Somfy 12 Volt WireFree™ Motor applications. DO NOT exceed the following:
A. Maximum Torque and blind dimensions. See motor data sheets / instruction Manuals.
B. Solar Pack Performance Tables (see Section 8).
2. Safety
2.1 Safety and Responsibility
Before installing and using this product, please read the installation guide carefully.
It is recommended that Solar Pack be installed by a professional motor installer, for
whom these instructions are intended.
Care must be taken for both new and existing installations due to the physical mounting
location of the motorized window covering - likely at the top of an interior window.
Consequently, pay attention to your personal safety in regards to proper use of ladders.
Care must also be taken to not drop hand tools or Solar Pack components from an
extended height.
Any usage outside of applications de ned by Somfy constitutes noncompliance,
and is therefore not covered by the warranty. In this event, as for all usage not consistent
with the instructions given herein, Somfy accepts no responsibility for harm or damage.
Never begin installing without  rst checking the compatibility of this product
with the associated equipment and accessories.

1) Never pierce the solar panel or its bezel frame.
2) Never put anything onto the solar panel (risk of scratching or breakage), especially during installation.
3) Once installed, never subject the wire harness or other components to strain, pinching, or cutting caused by moving objects.
4) Dispose of electronic components and batteries in accordance with local laws. Do not incinerate.
5) Never immerse this product in liquid (s).
6) Avoid Impacts
7) Do Not Recharge the battery with any charger other than a Somfy Solar Pack Charger.
The solar panel is a fragile part. Do not drop it. If Dropped, do not install as damage may not be visibly detectable and reduced performance may occur.
Refer to the Instruction Manual or Contact your Somfy Representative
Power Sources for 12 Volt WireFree™ Motors
WireFree™
Motor
12 Volt Battery Wand Battery Tube Solar Pack
Roll Up RTS √√√
Roll Up IR √√√
Tilt RTS √√√
Tilt IR √√√
Cord Lift RTS √√√
4. Connections
5. Commissioning
5.1 Activation of Motor
6. Product In Use
6.1 Normal Operation
6.2 Excessive Energy Use
7. Window Application Tables & Guidelines
8. Solar Pack Performance Tables & Solar Zones
EN

3. Installation
3.1 Determine Location of Solar Panel
The solar panel must always be installed indoors, directly against the window
glass so as to allow as much natural light as possible to reach the panel.
Caution! Never install the solar panel on any window glass allowing
less than 65% light transmission (including Low E glass and/or window
tinting), or obstructed by a window pane or bug screen. Always leave
the photovoltaic cells unobstructed, do not put anything in front of
them.
The three components which make up the Solar Pack must be installed on
the same side as the WireFree™ motor.
Somfy recommends that all components be tted systematically in order that
all components may be connected to the wire harness easily, and that the
wire harness does not interfere with the free movement of the interior window
covering.
Please Refer to the Solar Pack Performance Tables Section 8.0 to conrm
proper usage per blind and window orientation.
3.2 Mounting the Solar Panel.
Caution! It is imperative that window hardware or framing does not
collide with the solar panel!
Careful! Do not damage the wire harness cables during installation.
Determined the position of the solar panel (against window, within reach of
wire harness) prior to application of 2-sided tape to insure proper adhesion
the rst time.
3.2.1 Glass Mounting
Caution! To insure a secure adhesive hold over a long period, prepare
the inside window glass prior to mounting the solar panel.
Important! The adhesive tape should never be touched directly with
ngers (or other contaminates) prior to adhesion.
1) Clean solar panel bezel corners and window area with alcohol prep pad.
Let dry for two minutes.
2) On a table, with the solar panel facing up, apply the 2-sided adhesive to
four corners of the solar panel bezel.
Note: The tape is precut for your convenience in between the top (facer) and
bottom (backer) liners. With your ngers, lift off each precut adhesive piece so
that it remains attached to the “facer” material – and the opposite side of the
tape should then be released from the back liner. See Photo in Figure 1 and
Figure 2.
3) Remove the “facers” of the applied adhesive.
Position the bezel with solar panel facing to outdoors , then press entire panel
with rm, even pressure into the glass for 10- 15 seconds. The panel is now
supported by the adhesive to glass bond but will require 24 hours of cure time
to allow full strength characteristics. Do not disturb during this period.
Motor side Battery Tube:
Located near the top of
the window frame and
near the motor side.
May be hidden from
view.
Panel:
Located near
the top of the window
frame and near the
motor side. When fully
open, shade or fascia
may help conceal panel
from inside view.
Installed:
When fully open, shade
or fascia may help
conceal
Solar Pack from inside
view. Wire Harness is
tucked away.
Upper Liner
Master Liner
Adhesive must stay with upper liner
when peeled away from master liner
Figure 1.
Glass Mount Adhesive
Figure 2.
Apply to all 4 corners
Adhesive

3.3 Battery State of Charge
The Battery is shipped from the factory inside the battery tube with a partial
charge only.
3.3.1 Battery Preparation
Have a service professional fully charge the battery using the compatible
Somfy Solar Pack Rapid Charger (REF#9015781 - Solar Pack Charger).
Important! Refer to Solar Pack Wall Charger Instructions.
Caution! Use of another battery charger is a safety hazard, is
prohibited and voids the Somfy Warranty. Disconnect from AC wall
receptacle upon completion of charge.
Battery must be fully charged prior to installation. Do not exceed 5
days from time of 100% charge to installation or performance may not
be met.
3.4 Battery Tube Install Location
Once conditioned with a pre-charge, the battery tube assembly can be
secured and hidden from view either behind, inside or next to the window
covering product hardware.
The battery tube is compatible with Somfy Mounting Clips designed for
Shangri-La (REF# 9013266) & Silhouette (REF#9013264) window covering
products.
For outside of head rail mounting, optional battery tube wall mounting clips
are available (REF#9013263) for either vertical or horizontal positioning.
For blinds with box head rails, room may exist to place the battery inside the
rail without interference.
Caution! If installing the battery vertically, always position it with the
cable output upwards to reduce unrestrained wire from catching the
shade.
4. Connections
Caution! The wiring harness connecting the Solar Pack components
must be protected from the movement of the motorized window
covering.
Caution! Do not change the conguration of this system to include
different connectors.
1) Connect the wire harness to the motor.
2) Connect the solar panel to the wire harness
3) Connect the battery tube to the wire harness
5. Commissioning

If the Solar Pack is being installed as an upgrade to an existing Somfy
WireFree™ motorized shade installation, there is no need to reprogram the
motor.
If the Solar Pack is being installed with a new Somfy WireFree™ motor, follow
the motor installation guide.
Solar Pack Charger (REF# 9015781)
-sold separately.
SOLAR PACK BATTERY TUBE MOUNTING CLIPS (OPTIONAL)
WALL MOUNT CLIPS
REF#9013263
Horizontal or Vertical
Wall Mounting
Shangri La Mount Clips
REF# 9013266
Headrail Mounting
Silhouette Mounting
Clips REF# 9013264
Headrail Mounting
Vertical Battery Tube connector orientation
Motor Connector
Solar Panel +
Battery Tube
Connectors
Standard Installation Plan of Roll-Up Shade.

6. Product in Use
6.1 Normal Operation
After commissioning, the battery is trickle-charged by electrical energy generated by the solar panel. The energy is stored in the high capacity NiMH battery (acting
like a reservoir) and the system provides uninterrupted service through many climatic seasons. It is normal for the battery to gain more energy in summer as
compared to winter – the Solar Panel converts the intensity of light to energy upon availability.

Caution! If daily motor activations exceed recommended cycles per day as stated in the Solar Pack Performance Chart, the solar panel will not be able to
“replenish” the battery as designed.
If the motorized shade does not operate due to an excessively diminished battery, the battery may require a full recharge by a Somfy Service provider.
If the battery no longer provides adequate power to operate your motor, a freshly charged replacement battery & tube assembly may be ordered from your Somfy
dealer (REF#9015624) and there is no need to replace any other Solar Pack components.

8 Solar Pack

1a. Choose city or region on map based on map color.
1b. Choose closest city from tables provided.
2. Identify corresponding solar zone in the chart.
3. Determine window orientation (facing out north,south, east or west).
4. Determine shade drop.
5. Apply data to chart. Cross reference for answer.

Window Type
SINGLE OR
DOUBLE PANE OK
LIGHT
TRANSMISSION
65% OR GREATER
WINDOW TINTING INSIDE WINDOW
ONLY

During
Installation
The motor does not work 1. Verify wires have secure connection, and that wires are not cut.
2. Verify battery has been charged to 100%.
3. See Troubleshooting Section of Specic Motor (Roll-Up,Cord-Lift, or Tilt User Manual).
Solar Panel does not adhere
to glass after initial application.1. Remove panel and adhesive. Clean glass with glass prep pad. Dry. Apply new adhesive as directed.
Sliding window collides with
solar panel after mounting. 1. Install a window bumper to prevent collision.
2. Install optional solar panel mounting bracket.
Solar Pack loses charge
BEFORE 3-5 years of use. 1. Contact Service provider to recharge battery to 100%.
2. Review Solar Pack Performance Chart & Section 7.0 Window Application Tables & Guidelines.
Solar Pack loses charge
AFTER 3-5 years. Purchase fully charged replacement Solar Pack Battery from your Somfy Reseller REF #9015624.
After
Installation

AWNINGS OR DEEP
ROOF EVES
WINDOW DIVIDERS
OVERLAPPING
SOLAR PANEL
VEGETATION
BLOCKING LIGHT
BUG SCREENS

Window
FIXED WINDOW DOUBLE HUNG SLIDING CASEMENT
Concern Clean Install Caution:
Avoid Panel Collision
Caution:
Avoid Panel Collision
Caution:
Panel Movement Will
tug or tear Harness
Suggestions Limit Screw in track Limit Screw in Track Cable tie near corner

SOLAR PACK FOR WIREFREE™ MOTORS
REPLACEMENT ENERGY CHART BASED ON CYCLES / DAY FOR ROLL-UP, CORD LIFT & TILT
Cycles per day for this orientation and shade size
SHADE LENGTH
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
up to 5 feet (1.5 M)
5 to 8 feet (1.5 M - 2.4M)
North
1
N/A
1
N/A
1
N/A
2
1
2
1
2
1
2
1
West
1
N/A
1
1
2
1
2
1
3
2
3
2
3
2
East
1
N/A
1
N/A
2
1
2
1
3
1
3
1
3
2
South
1
N/A
2
1
3
1
3
2
4
2
4
2
4
3
Solar
Region
Zone 0
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
Solar Pack 