Sonance ASBPC6RS User manual

Remove the paint shield from the finished
mounting platform.
Cut the four tabs on the sanding shield
support structure on the bracket. NOTE: The
port tube tether is connected to the zip
tie for easy access.
Remove sanding shield support structure. Use the
tether to guide the port tube through the back of
the mounting platform. Do not remove foam insert
from port tube yet.
1
3
2
Port Tube
Tether
Pull port tube down and expose all extra port tube
through speaker opening. Remove foam insert
from port tube. Cut and remove extra port tube
material, leaving 3 ribs or 1 5/8” (41mm) below
ceiling surface.
4
(1) Quickstart guide
(1) Bandpass connector
(1) Round grille
(1) Square grille
(1) Hose clamp for port tube
(1) Grille painting instructions
(1) Set of speaker screws w/ Loctite®
Box Contents
A.S. BANDPASS CONNECTOR QUICKSTART GUIDE
ASBPC3RS AND ASBPC6RS (ROUND AND SQUARE)
SONANCE ARCHITECTURAL SERIES®

9
06.26.17
33-5947
Place the hose clamp (A) around the ASBPS porttube.
Slide the port tube over the bandpass connector (B).
Orient the port tube on the bandpass connector so
the mounting screw locations in the bracket and
bandpass connector line up.
7 8
6
A
B
If it is not possible to locate the BPS8 Subwoofer 12”
away from the bandpass connector, the extra hose
material (up to 8”) must be removed. While it is ok
to shorten the hose, never extend the hose length.
5
BPS8
BPS8
GOOD
BAD
The leveling ring is for fine adjustment. If necessary
adjust the magnetic grille leveling ring with a screwdriver
so grille installs flush to the ceiling surface. Remove the
scrim cloth (for BPS8 Subwoofer applications) and install
the grille. NOTE: See grille painting instructions.
Tighten the hose clamp around the bandpass connector
and port tube. The slots in the mounting platform allow
clearance for the hose clamp. Orient the hose clamp
to go through one of the openings. Place the port tube
and connector into the mounting platform.
Apply Loctite® to screws and screw bandpass
connector to mounting platform.
©2017 Sonance. All rights reserved.
Sonance, Architectural Series, and Visual Performance
are registered trademarks of Dana Innovations.
Due to continuous product improvement, all features
and specifications are subject to change without notice.
For the latest Sonance product specification
information, visit our website: www.sonance.com
SONANCE
212 Calle Amanecer
San Clemente, CA 92673 USA
[phone]
FAX: [phone]
Technical Support: [phone]
www.sonance.com
For wiring diagrams and detailed eManuals visit
http://www.sonance.com/in-wall-in-ceiling/
architectural-series/medium-speaker-subwoofer