Sonder CHESTER FG0801372 User manual

PART LIST
A [ 1] MARBLETOP
B [ 4] CONNECTORMETAL FRAME
C [ 2] DRAW ERBOX
D [ 4] METAL BASE
Thank you for choosing this quality product. Be sure to check all packaging materials carefully for small parts that may have become
loose during shipment and place all parts on a non-abrasive surface.
IMPORTANT :These parts can be cumbersome and heavy to some people, therefore the assistance of two or more people is
recommended in order to prevent personal injury and ensure the furniture is not damaged during the assembly Process.
CHESTER DESK
NO D ESCRI PT I O N QTY
1
2
HARDWARELIST
ALLEN WRENCH 1
INSTRUCTIONS
1. Gently, lay the Marble top (A) upside down on a soft flat
surface. Attach the Connector metal frame (B) into the
Marble top, align and insert Allen bolt (1) to each fixed
nuts under top through the hole on the top of the metal
frame. Tighten all the bolts by using wrench (2). DO
NOT OVERTIGHTEN. See FIGURE 01.
2. Repeat for other connector metal frame.
ALLEN HEAD BOLT 48
CAREINSTRUCTIONS
1. Dust often using a clean, soft, dry and lint-free cloth.
2. Blot spills immediately and wipe with a clean, damp, cloth.
3. We do not recommend the use of chemical cleansers,
abrasives or furniture polish on our lacquered finish.
IMPORTANT SAFETY INSTRUCTIONS
1. Please read all instructions carefully before assembling.
2. For your safety, assembly by two or more adults is strongly recommended.
3. Keep instructions for future use.
4. Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the item.
SO N D ER
L I V I N G
12
/

3. Gently, lay the back of the drawer box
(C) on a soft flat surface. Attach the
Metal base (D) into the bottom of the
drawer box, align and insert Allen bolt
(1) to each fixed nuts under drawer
box through the hole on the top of the
metal base. Tighten all the bolts by
using wrench (2). DO NOT OVER
TIGHTEN. See FIGURE 02.
4. Repeat to attach other metal base
with second drawer box.
5. After assembly, bring the both of the
drawer box upright on flat surface.
6. P
reset the both of base assembled on
your desired location. Distance
between the inside surface of the both
drawer box should be 624mm. See
FIGURE03.
7. Bring the Top assembled and set it on
the top of the base. Align the metal
frame with fixed nuts on the top of the
drawer box. Once the metal frame is
set, insert Allen bolt (1) as FIGURE04.
624mm
22
/