Sonder CHESTER FG0801380 User manual

PART LIST
A [ 1] TABLETOP
B [ 2] EXTENDERSHELF
C [ 2] BASE
Thank you for choosing this quality product. Be sure to check all packaging materials carefully for small parts that may have become
loose during shipment and place all parts on a non-abrasive surface.
IMPORTANT :These parts can be cumbersome and heavy to some people, therefore the assistance of two or more people is
recommended in order to prevent personal injury and ensure the furniture is not damaged during the assembly Process.
CHESTER EXTENDING DINING TABLE
NO D ESC RI PT I O N QTY
1
2
3
4
HARDWARELIST
LOCK WASHER 16
PLAIN WASHER
ALLEN WRENCH
16
1
INSTRUCTIONS
1. Gently, lay the table top (A) upside down on a soft flat
surface. Attach the table base into the table top, align
and insert Allen bolt (1) together with lock washer (2)
and flat washer (3) to each fixed nuts under top through
the hole on the top of the base. Tighten all the bolts by
using wrench (4). DO NOT OVERTIGHTEN. See
FIGURE 01.
2. After assembly, turn the table upright on a flat surface.
ALLEN HEAD BOLT 16
CAREINSTRUCTIONS
1. Dust often using a clean, soft, dry and lint-free cloth.
2. Blot spills immediately and wipe with a clean, damp, cloth.
3. We do not recommend the use of chemical cleansers,
abrasives or furniture polish on our lacquered finish.
IMPORTANT SAFETY INSTRUCTIONS
1. Please read all instructions carefully before assembling.
2. For your safety, assembly by two or more adults is strongly recommended.
3. Keep instructions for future use.
4. Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the item.
4
1
2
3
FIGURE 01
SO N D E R
L I V I N G
C
C
A
13
/

3. Unlock the metal locks under Table
top , open the top panel, put the
Table leaves (B) at the middle of
table top. Make sure the exposed
tennon on the side edge of panels
align with pre-drilled holes on the
side edge of panels. Close top panels
and lock the metal locks under Table
top.See FIGURE02 & 03.
4. Check the table leveling, and adjust
the levelers at the bottom of the base
if necessary. See FIGURE 04.
Metal lock
Leveler
23
/

OPTION: THETABLEWITHOUT EXTENDERSHELF
a. Unlock the metal locks
under Table top, open the
top panel maximum, then
gently bring the extender
shelf and remove from the
table top. See FIGURE A.
b. Step by step bring the each
of extender shelf and place
them into the inside of the
table top as in FIGURE B.
c. Closing the table top and
lock the metal locks under
Table top as in FIGURE C.
Metal lock
Metal lock
33
/