Sony CCMA-2DAR Instruction Manual

910
6
21
8
4 5
7
3
1 2
1
2
Camera head
(MCC-1000MD)
Camera adapter
(CCMA-2DAR)
Operating Procedure
Microscope Connection Guide for the CCMA-2DAR Adapter
and the MCC-1000MD
Connecting to the Leica M525
Connection
Connect the camera cable to the camera head.
*Align the cable slot with the top of the camera head, and turn the cable ring to secure it.
Connection setup is
complete (finished state).
Connect the controller to
the adapter by pushing
inwards until it clicks;
there is no need to turn
the controller.
Insert the adapter into
the microscope (gently,
with both hands).
Attach the Leica attachment to the adapter while turning its
mount ring.
Attaching the camera head (MCC-1000MD) to the adapter.
• Align the lens mount thread of the camera head with the camera adapter connector, then turn the camera head
clockwise to secure it to the unit. At this time, please do not align the planes of the camera and the adapter forcibly.
Remove the camera head cap.
Remove the camera connector cap.Remove the front lens
cap of the camera
adapter.
Pull off the microscope
cap.
Preparation
Insert two AA batteries into the
controller.
Print the chart for adjusting the viewing
angle position onto A4-size paper.
Camera adapter with
the Leica attachment
Mount ring
1. Leica M525
2. Controller cable
3. Camera head (MCC-1000MD)
4. Controller
5. Attachment for Leica
6. Camera adapter (CCMA-2DAR)
6
5
4
32
1

Operating Procedure
MK20402V1OHB20JAN
123
654
1 2 3
3
20~30 cm
For the controller cable, slide the joint and pull it
directly out.
For the camera cable, pull it out while turning the
ring of the joint.
For the camera head, turn the main unit to
remove/attach it (make sure to disconnect the
camera cable).
Advice on Cable Disconnection
Adjusting
the Viewing
Angle Position
If iris adjustment is required, turn
the dial to adjust the iris setting.
TIPS
If the remote control does not work due
to the deterioration of battery
performance, you can use the adapter’s
FOCUS dial to adjust the focus (For
emergency purposes only; be careful
not to touch the clean field.)
While viewing the chart displayed on the
monitor, adjust the focus by holding down
the NEAR and FAR buttons on the controller.
Now use the hexagonal wrench to
adjust the up, down, left, and right
positions so that your chart
appears in the center of the
monitor.
While viewing the monitor, adjust
the rotation by using a hexagonal
wrench to loosen the screw
securing the camera adapter and
camera head, then tighten the
screw with this wrench to secure
the screw again.
While looking through the
microscope’s ocular lens, centrally
place the chart printout (your chart
for adjusting the viewing angle
position). The recommended
working distance is 20~30 cm.
Focus wrong
Focus correct
Turn on power to the MCC-1000MD,
M525 and monitor to display your
chart on the monitor.
Microscope Connection Guide for the CCMA-2DAR Adapter
and the MCC-1000MD
Connecting to the Leica M525
Support call:
Email: