2004 SONY MOBILE
PRODUCT GUIDE
CDX-F5500
FM/AM Compact Disc Player
Audio Power Specifications
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5%
total harmonic distortion
Note
This unit cannot be connected to a digital preamplifier or an equalizer
which is Sony BUS system compatible.
Design and Specifications subject to change without notice.
CD Player Section
Signal-to-noise ratio 120 dB
Frequency Response 10 - 20,000 Hz
Stereo Separation 85 dB
Total Harmonic Distortion 0.01%
Tuner Section
FM AM
Tuning Range 87.5 - 107.9 MHz Tuning Range 530 - 1,710 kHz
Antenna Terminal External antenna connector Antenna Terminal External antenna connector
Intermediate Frequency 10.7 MHz/450 kHz Intermediate Frequency 10.7 MHz/450 kHz
Usable sensitivity 9 dBf Sensitivity 30 µV
Selectivity 75 dB at 400 kHz
Signal-tp-noise ratio 67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz 0.5% (stereo), 0.3% (mono)
Separation 35 dB at 1 kHz
Frequency response 30 - 15,000 Hz
Outputs Speaker outputs (sure seal connectors)
Speaker impedance 4 - 8 ohms
Maximum power output 52 W x 4 (at 4 ohms)
Power Amplifier Section
General
• MP3 Playback
• Station Memo
• Front preamp output
• Rear/Sub selectable preout
w/LPF
• CD/MD changer control, CD Text
• Flip-down detachable faceplate
• DSO, EQ3
• 52W x 4 high power
• Drive-S
• 8fs, 1-bit D/A converter
• 45 degree install
• CD-R/RW playback
• SSIR-EXA tuner
• 18FM + 12AM memory presets
• Blue 13-segment LED display
• Red key illumination
• Supplied wireless card remote
(RM-X115)
• Optional wired rotary remote
(RM-X4S)
Preamp Output Level 2 Volts
Preamp Impedance 220 ohms
Outputs Audio outputs (front, rear/sub selectable)
Power antenna relay control terminal
Power amplifier control terminal
Inputs Telephone ATT control terminal
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna input terminal
Tone controls Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1kHz (XPLOD)
High: ±10 dB at 10kHz (XPLOD)
Power requirements 12 V DC car battery (negative ground)
Dimensions Approx. 178 x 50 x 177 mm
(7 1/16 x 2 x 7 in.) (w/h/d)
Mounting dimensions Approx. 182 x 53 x 161 mm
(7 1/4 x 2 1/8 x 6 3/8 in.) (w/h/d)
Mass Approx. 1.2 kg (2 lb. 10 oz.)
Supplied accessories Card remote commander (RM-X115)
Parts for installation and connections
Front panel cover (1)
Optional accessories Rotary remote commander (RM-X4S)
Plug shown with wires facing viewer
Pin Number Wire Color Description
1 White Left front +
2 Green Left rear +
3 Purple Right rear +
4 Gray Right front +
5 Blue/white AMP Remote
6 Blue ANT Remote
7 Red Accessory
8 Black Ground
9 White/black Left front -
10 Green/black Left rear -
11 Purple/black Right rear -
12 Bray/black Right front -
13 Sky blue ATT
14
15 Orange/white Illumination
16 Yellow Battery
Harness Plug Configuration
1 2 345678
9 1011 12 13 14 15 16
