
NPLAY
M
m
VOLUME
xSTOP
PRESET +/–
CFM
AM
B
FWD
REV
MODE•
s/d
DIR•Y
i
TUNING +/–
ENTER
FM
AM
RADIO OFF
HOLD
MENU
SET
English
Playing a Tape B
1Insert a cassette and press MENU
repeatedly to set the cursor to TAPE in the
display. Then press SET to select the tape
type.
No message: normal (TYPE I)
METAL: High-position (TYPE II) or metal
(TYPE IV)
2Press NPLAY.
Adjust the volume with VOLUME.
To Press
Stop playback xSTOP
Wind rapidly* M or m
* If you leave the unit after the tape has been wound or
rewound, the batteries will be consumed rapidly. Be
sure to press xSTOP.
Note
• Do not open the cassette holder while the tape is
running.
To select playback mode
Switch MODE to select the desired mode.
To play Select
Both sides repeatedly s
Both sides once from the side facing d
the cassette holder (FWD)
To select the tape direction
Switch YDIR to select the desired direction.
Listening to the Radio
1If the HOLD function is turned on, set the
HOLD switch in the opposite direction of
the G mark to unlock the controls.
Make sure that the tape has stopped
completely.
2Press FM or AM to select the desired band
and turn on the radio.
3Press TUNING +/– to tune in to the
desired station. Hold down TUNING +/–
for a few seconds to scan for stations.
To turn off the radio
Press RADIO OFF.
To improve broadcast reception C
•For FM: Extend the headphones/earphones cord
(antenna). If the reception is still not good, press
MENU repeatedly to set the cursor in the display
to FM MODE. Then press SET to switch between
“LOCAL” and none (DX), or ”MONO” (monaural)
and none (stereo) for best reception.
•For AM: Reorient the unit itself.
Presetting Radio Stations
You can preset up to 40 stations.
For Canada and Central/South America: 30 for FM
and 10 for AM.
For other countries: 35 for FM and 5 for AM.
Presetting Automatically Scanned
Stations
1Press FM or AM.
2Press ENTER for more than 3 seconds.
Preset number 1 will flash in the display
and the Walkman starts scanning the
stations from the lower frequencies and
stops for about 3 seconds when a station is
received.
3If you wish to preset the received station,
press ENTER while the preset number is
flashing.
The received station is preset on preset
number 1 and the unit starts scanning for
the next receivable station.
4Repeat Step 3 until all receivable stations
are preset.
To stop scanning
Press RADIO OFF. The radio is turned off at the
same time.
Notes
• If stations are already stored, the newly preset
stations replace the old ones when the above
procedure is completed.
• If stations cannot be preset automatically, preset
stations manually.
Presetting Stations Manually
1Press FM or AM.
2Press ENTER.
The frequency digits and a preset number
flash in the display.
3While the frequency digits and the preset
number are flashing, tune in to a station
you wish to store using TUNING +/–, and
select a preset number using PRESET +/–.
4While the frequency digits and the preset
number are flashing, press ENTER.
Notes
• If you cannot complete step 3 or 4 while the
indications are flashing, repeat from step 2.
• If a station is already stored, the new station replaces
the old one.
To cancel the stored station
Follow the procedure above and in step 3, press and
hold TUNING +/– until “- - - -” is displayed and
select the preset number you want to cancel using
PRESET +/–. Press ENTER while “- - - -” is flashing.
Playing the preset radio stations
1Press FM or AM.
2Press PRESET +/–.
Using Other Functions
Locking the controls
Set the HOLD switch in the direction of the G mark
to lock the controls.
The hold function only locks the radio operation
buttons, MENU button and SET button.
Emphasizing bass sound
Press MENU repeatedly to set the cursor to MEGA
BASS in the display. Then, press SET to turn MB
(mega bass) on. With each press, the indications
change as follows.
MB (mega bass) : emphasizes bass sound
No message: off (normal)
Notes
• If the sound is distorted with the mode “MB”, turn
down the volume or select normal mode.
• Bass emphasis may not show great effect if the
volume is turned up too high.
Protecting your hearing—AVLS
(Automatic Volume Limiter
System)
Press MENU repeatedly to set the cursor to AVLS in
the display. Then press SET to show “AVLS”.
The maximum volume is kept down to protect your
ears.
中文
播放磁帶
B
1插入盒帶,並反復按MENU鈕在顯示窗中將游
標設於TAPE。然後按SET鈕選擇磁帶類型。
無訊息︰正常(TYPE
I)
METAL︰高位(TYPE
II)或金屬帶(TYPE
IV)
2按N
PLAY鈕。
用VOLUME鈕調節音量。
要按
停止播放 x
STOP
快繞* M
或
m
* 如果磁帶已捲帶或倒帶後仍讓本機運行,電池將很快
耗盡。務必按 xSTOP鈕。
註
•磁帶在運行中不要打開盒帶座。
選擇播放模式
切換MODE 開關選擇需要的模式。
要播放 選擇
雙面反復播放 s
從朝盒帶座的一面開始 d
雙面播放一次(FWD)
選擇磁帶方向
切換Y
DIR開關選擇需要的方向。
收聽無線電
1如果HOLD功能打開,將HOLD開關沿G相反
方向滑動以解開控制鈕。
確認磁帶已完全停止。
2按FM或AM鈕選擇需要的波段並打開無線電。
3按TUNING
+/-鈕調入需要的電臺。按住
TUNING
+/-鈕幾秒鐘掃描電臺。
關閉無線電
按RADIO OFF 鈕。
改善廣播接收
C
•對於FM︰延長頭戴耳機耳機線(天線)。如果接
收依然不良,請反復按MENU鈕在顯示窗中將游標設
於FM MODE。然後按SET鈕在 "LOCAL"和“無(DX)”
之間,或“MONO(單聲道)”和“無(立體聲)”之間
切換以選擇最佳的接收。
•對於 AM ︰重新定向本機。
預設電臺
您可以預設多達40 個電臺。
對於加拿大和中南美洲:FM 30個臺,AM 10個臺。
對於其他國家:FM 35個臺,AM 5個臺。
預設自動掃描的電臺
1按FM或AM鈕。
2按ENTER鈕3 秒鐘以上。
預設號1將在顯示窗上閃爍。Walkman(本機)
開始從低頻段掃描電臺,在接收到電臺時停
止約3秒鐘。
3如果您要預設接收到的電臺,在預設號閃爍
時按ENTER鈕。
接收到的電臺被預設於預設號1 ,本機開始
掃描下一個可接收的電臺。
4重複步驟3直至所有可接收電台均被預設。
停止掃描
按RADIO OFF 鈕,無線電同時關閉。
註
•如果電臺早已預設,當完成上述步驟時,新預設的電
臺就取代原有的電臺。
•如果電臺不能自動預設,就手動預設電臺。
手動預設電臺
1按FM或AM鈕。
2按ENTER鈕。
頻率數字和預設號在顯示窗上閃爍。
3當頻率數字和預設號閃爍時,用TUNING
+/-
鈕調入您想儲存的電臺,並用PRESET
+/-鈕
選擇預設號。
4當頻率數字和預設號閃爍時,按ENTER鈕。
註
•如果上述指示閃爍時您不能完成步驟3 或步驟 4,請
從步驟2開始重複操作。
•如果電臺早已儲存,新電臺就取代原有的電臺。
取消儲存的電臺
遵循上述步驟,並在步驟3 按和按住TUNING
+/-鈕
直到“-
-
-
-”顯示,用PRESET
+/-鈕選擇您要取消
的預設號。在“-
-
-
-”閃爍時按ENTER 鈕。
播放預設的電臺
1按FM或AM鈕。
2按PRESET
+/-鈕。
使用其他功能
鎖定控制鈕
將HOLD 開關設於
G
標誌方向以鎖定控制鈕。
保持功能僅鎖定無線電操作鈕、MENU 鈕和SET 鈕。
加重低音聲
反復按MENU鈕在顯示窗中將游標設於MEGA BASS。然
後按SET鈕打開MB(強低音)。每按一次,指示改變
如下。
MB(強低音)︰加重低音聲
無訊息︰關閉(正常)
註
•如果聲音因“MB”模式而失真,請關閉音量或選擇正
常模式。
•如果音量調得太高,低音加重可能沒有很大效果。
保護您的聽覺─AVLS(自動音量限制系統)
反復按MENU鈕在顯示窗中將游標設於 AVLS,然後按
SET鈕顯示“AVLS”。
最大音量被降低以保護您的耳朵。