PCG-K Series CD/DVD Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N T99860099 Rev. B 2/2
Step 6.Rotate the PC. The CD/DVD drive should be facing
you. IMPORTANT! Ensure that all three (3) screws from step 5
have been removed. Slide open the CD/DVD drive by grasping
the tray at both sides as shown above and slowly pull the drive
away from the PC. NOTE: Some force may be required to
initiate the removal of the CD/DVD tray.
Step 7.Gently insert the new CD/DVD drive into the unit as
shown in the picture. Push both sides of the drive faceplate with
equal force toward the PC. When done properly, the drive
faceplate should be flat with the PC, and the screw holes should be
aligned with the screw openings.
Step 4.Using the enclosed magnetic screwdriver,
remove the marked screw and door as shown and set them
aside.
Step 8.Using the enclosed
magnetic screwdriver, reinstall
the three (3) previously
removed screws.
CAUTION! Be careful not to
drop screws into the inside of
the unit, and be careful to use
the correct screws, as shown
in the picture. Do not over
tighten the screws!
Step 9.Using the
enclosed magnetic
screwdriver, reinstall
the external door and
screw. Return the
defective CD/DVD
drive to Sony following
the included shipping
instructions.
Step 5.Using the enclosed magnetic screwdriver, remove
the three (3) screws as indicated in the picture. CAUTION! Be
careful not to drop screws into the unit
Faceplate should be flat
with edge of PC
