Sony VPCEF Series Guide

VPCEF Series Optical Disk Drive
Replacement Instructions
P/N 9892 1981 Rev. B 1/3
Prepare the Computer
CAUTION: Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Step 1. Place the computer upside
down on a protected surface with the
front edge facing you.
Battery Pack Removal
Step 2.
1) Slide the Left battery tab to the
unlock position.
2) With your Right thumb, slide the
Right battery tab to the Left and
hOld.
3) Lift the battery with your Left thumb
using the notch at the bottom to
remove.
Optical Drive Removal
(Steps 3-6)
Step 3. The Optical Disk Drive (ODD)
is located on the Left side of the unit
as shown.
These easy instructions are intended to guide you through the replacement process.
Before you begin, place your notebook computer on a clean or covered surface to avoid
damage to the computer's case.*
ollow the ESD (Electrostatic Discharge) damage prevention instructions:
oHOld parts by the edges, away from exposed circuitry when possible.
oDo not walk around excessively as this promotes static build-up.
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface
of your notebook computer.*
The appearance of the electronic components shown in the illustrations may be different from
the components shipped. This slight difference does not affect the accuracy of these
instructions.
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.
IMPORTANT!
PLEASE READ BEFORE YOU START
Lift to remove
2
.
3
.
1
.

VPCEF Series Optical Disk Drive
Replacement Instructions
P/N 9892 1981 Rev. B 2/3
Step 4.
Using the enclosed magnetic
screwdriver, remove the screw securing
the ODD Bay. Put aside the ODD Bay
screw to re-secure the ODD Bay later
in the procedure.
Step 5.
Insert your fingers in the space
between the ODD and the unit . Gently
pull towards the Left to remove the
ODD.
Step 6
.
Carefully remove the ODD
assembly from the unit.
O
DD Disassembly (Steps 7
-
9)
Step 7. Identify the four (4) side screws
that secure the ODD Brackets to the
ODD.
Step
8
.
Remove the screws & bracket.
Put the ODD Bracket and screws
aside for transfer to the New ODD.
S
t
ep 9
.
Arrange the bracket & screws
as shown above. Set the Old ODD
aside.
Step 11. Align the tabs on the Bezel
with the tab holes located on the
ODD. Carefully press the Bezel into
place.
O
DD Assembly (Steps 10
-
13)
Step 10. Take the New ODD and Bezel
provided in the CRU kit and prepare for
assembly.
N
OTE:
Identify
the
tabs on the
Bezel
and tab holes located on the ODD.

VPCEF Series Optical Disk Drive
Replacement Instructions
P/N 9892 1981 Rev. B 3/3
Step 12. Position the New ODD (Label
side down) The bracket should be
aligned on the Right side of the ODD.
Take note of the proper alignment of the
screw holes.
Step 13. Using the ODD Screws, install
the ODD Brackets onto the New ODD.
NOTE: All brackets should sit flush
with the ODD.
ODD Installation (Steps 14-16)
Step 14. Align the ODD assembly
properly (label side down) and slide into
the computer.
Step 15. Make sure the New ODD is
seated flush on the edge of the
computer.
Step 16. Reinstall the ODD Bay
screw to secure the ODD Assebmly.
Step 17. Reinstall the battery pack and
AC Adaptor.
Return the Old ODD to Sony
following the included
shipping instructions.