Sony VGN-SR130N Guide

VGN-SRxx Series Optical Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N Rev. X2 1/2
Step 1. Prepare the Computer.
CAUTION: Make sure the computer
is turned off, the lid is closed, and the AC
Adapter is disconnected. Failure to do so
can result in damage to the computer.
Place the computer upside down on a
protected surface with the front edge
facing you.
Step 2. Remove the Battery Pack.
1. Slide the left battery tab to the
unlock position.
2. With your right thumb, slide the
right battery tab in the release
direction and hold.
3. Remove the battery by lifting the
side where the arrow is pointing.
(ODD Removal) Steps 3-8
Step 3. Locate ODD Bay, Memory
Access Cover and HDD Access Cover.
Rotate the computer with the Optical
Disk Drive (ODD) Bay facing you as
shown in the picture. The Memory and
HDD access covers will need to be
removed to reveal the screws securing
the ODD in place.
These easy instructions are intended to guide you through the replacement process. If you need
additional help, please call 1-866-651-7669 for technical support from 9:00 am to 11:00 pm EST.
9Before you begin, place your notebook computer on a clean or covered surface to avoid
damage to the computer's case.*
9Follow the ESD (Electrostatic Discharge) damage prevention instructions:
oHold parts by the edges, away from exposed circuitry when possible.
oDo not walk around excessively as this promotes static build-up.
9Remove jewelry before you begin work to avoid scratching the surface of your notebook
computer.*
9The appearance of the electronic components shown in the illustrations may be different from
the components shipped. This slight difference does not affect the accuracy of these
instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony limited warranty
continue to a
pp
l
y
.
IMPORTANT!
PLEASE READ BEFORE YOU START
ODD Bay
Lift to remove
Push left tab in the unlock position
Memory
A
ccess
Cover
1.
2
.
3
.
HDD Access Cover

VGN-SRxx Series Optical Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N Rev. X2 2/2
Step 4. Using the magnetic screwdriver,
loosen the four screws securing the Memory
and HDD access covers.
Step 5. Remove the Memory and HDD
access covers. Start by lifting from the side
where the screws held them in place.
Step 6. Remove the two (2) screws shown
in the picture. These are the screws that
secure the ODD in place.
Step 7. To initiate the removal of the ODD
Bay, pull slightly the ODD door as shown in
the picture.
Step 8. With even force, slide out the ODD
as shown. Some force may be required to
unlock the ODD from the connector.
(ODD Reinstallation) Steps 9-12
Step 9. Hold the new ODD Bay by the
edges and align it with the opening.
IMPORTANT! Install the new ODD in the
correct position as shown in picture.
Step 10. Make sure the new ODD Bay is
seated flush on the edge of the computer.
Step 11. Reinstall the two (2) screws
securing the ODD in place.
Step 12. Reinstall the Memory and HDD
access covers.
Reinstall the battery pack. Return the old
ODD to Sony following the included
shipping instructions.