Sony BDV-HZ970W (UWA-BR100) User manual

2Thread the speaker cord () into the bottom of the post (or ) and
out the opposite end.
You can choose either the long posts () or the short posts () to assemble the
speakers.
Screw holes



or

3Thread the speaker cord () through the hole on the bottom of the
speaker () and out the hole on the rear.


4Insert the post (or ) into the hole on the bottom of the speaker
(), so that the screw on the top of the post faces the front of the
speaker.
Screw
or 

5Secure the post (or ) with the screws ().

or 
6Connect the speaker cord (). Then, secure the speaker cord by running
it through the slit.
Connect the speaker cord with the colored tube to , and the speaker cord without the
colored tube to .
Colored
tube
Slit

Label
Note
Match the color of the tube and label.
Continued 
Speaker Installation
Guide
4-187-308-11(1)
BDV-HZ970W
© 2010 Sony Corporation Printed in Malaysia
(1)
Assembling the front speakers
Required parts

×2 ×2 ×8
 
×2
Front speaker (R):
with red colored tube
Front speaker (L):
with white colored tube
×2×2
1Thread the speaker cord () through the bottom hole in the base
().


Colored tube

7Insert the post (or ) so that the slot on the lower post aligns
with the projection of the base (), then secure the post with the
screws ().


or 
Slot
Projection
Connecting the speaker cord to the center speaker and surround
speakers
Required parts
×2×3 ×1
Center speaker:
with green colored tube
Surround speaker (R):
with gray colored tube
Surround speaker (L):
with blue colored tube

Connect the speaker cord with the colored tube to , and the speaker
cord without the colored tube to .
Rear of the speaker
Connector Colored tube
Note
Match the color of the tube and the label on the speaker. The label is located at the rear of the
speaker.
Connecting the speaker cord to the subwoofer
Required parts
×1
Subwoofer:
with purple colored tube
×1

1Connect the speaker cord to the subwoofer.
Colored tube
Bottom of the subwoofer


2Thread the speaker cord through the gap along the side of the
subwoofer, and secure it in the speaker cord holder.
