For
safety, be sure
to
install this
unit
in
the
dashboard
of
the
car
as
the
rear side
of
the
unit
becomes
hot
during use.
For
details, see ·connection/Installation·
(page
26)
.
The nameplate indicating operatingvoltage, etc., is
located on
the
bottom
of
the
chassis.
The validity
of
the
CE
marking is restricted
to
only
those countries where
it
is legally enforced, mainly
in
the
countries
EEA
(European Economic Area).
Warning
To
prevent
fire
or
shock hazard,
do
not
expose
the
unit
to
rain
or
moisture.
To
avoid
electrical shock,
do
not
open
the
cabinet. Referservicing
to
qualified
personnel
only.
FOR THE CUSTOMERS
IN
THE USA. NOT
APPLICABLE
IN
CANADA, INCLUDING IN THE
PRO~INCE OF QUEBEC.
POUR
LES
CLIENTS
AUX
ETATS-UNIS.
NON
APPLICABLE AU CANADA, Y COMPRIS
LA
PROVINCE DEQUEBEC.
This
equipment
has been tested and found
to
comply
with
the
limits
for
a
Class
Bdigital device,
pursuant
to
Part
15
of
the
FCC
Rules. These limits
are designed
to
provide reasonable protection
against harmful interference in a residential
installation.This equipmentgenerates, uses, and
can radiate radio frequency energy and,
if
not
installed and used in accordance
with
the
instructions, maycause harmful interference
to
radio communications. However, there is
no
guarantee
that
interference will
not
occur in a
particular installation.
If
this equipmentdoes
cause harmful interference
to
radio
or
television
reception, which can be determined byturning
the equipment
off
and on,
the
user
is
encouraged
to
try
to
correct
the
interference by
one
or
more
of
the
following measures:
-Reorient
or
relocate
the
receiving antenna.
-Increase
the
separation between the
equipment
and
receiver.
-Connect
the
equipment into an outleton a
circuit different
from
that
to
which
th
e receiver
is connected.
-Consult
the
dealer
or
an experienced radio/TV
technician
for
help.
You
are cautioned
that
any changes
or
modifications
not
expresslyapproved in this
manual could void
your
authority
to
operate this
equipment.
This device complies
with
Part
15
of
the
FCC
Rules
and IndustryCanada's licence-exempt
RSSs.
Operation is subject
to
the following
two
conditions:
(1)
This device
may
not
cause interference; and
(2)This device
must
accept any interference,
including Interference that maycause undesired
operation
of
the
device.
Thistransmitter
must
not
beco-located
or
operated
in conjunction
with
anyotherantenna
or
transmitter.
UnderIndustry Canada regulations, this radio
transmitter mayonlyoperate using an antenna
of
a
type
and maximum (or lesser) gain approved
for
the
transmitter
by
IndustryCanada.
To
reduce
potential radio interference
to
other users,
the
antennatype and its gain should be
so
chosen
that
the
equivalent isotropicallyradiated
power
(e.i.r.p.)
is
not
morethan
that
necessary
for
successful
communication.
This equipment complies
with
FCC/IC
radiation
exposure limits set forth
for
an uncontrolled
environment and meets
the
FCC
radio frequency
(RF)
Exposure Guidelines and
RSS-102
of
the
IC
radio frequency
(RF)
Exposure rules. This
equipmenthas very
low
levels
of
RF
energy
that
is
deemed
to
comply
without
maximum permissive
exposure evaluation
(MPE).
If
you
have
any
questions
about
this product:
Visit:
www
.sony.com/support
Contact: Sony CustomerInformationService Center
at
1-
800
-
222
-7669
Write: SonyCustomer Information Service Center
12451
Gateway Blvd., Fort Myers,
FL
33913
Supplier's Declaration
of
Conformity
Trade Name:
SONY
Model:
XAV-V10BT
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo,
San
Diego,
CA
92127
U.S.A.
Telephone Number: 858-942-2230
This device complies with part
15
of
the
FCC
rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
This device may not cause harmful interference,
and
(2) this device
must
accept any interference
received,
including interference
that
maycause undesired
operation.
For
the
State
of
California, USA
only
Perchlorate Material -special handling may
app
l
y,
See
www
.dtsc.ca.gov/hazardouswaste/perchlorate
