Sorbent System 22M004 User manual

1
Use and Maintenance Manual
Table bag opener machine

2
Electric Shock
*Operate carefully and strictly prohibit destroy
the electrical parts and do not touch the electric
cabinet while power is supplied.
Rolling Keep Clear
*Do not put anything to the roll, it may cause
accident when something stops it running
smoothly.
Danger of the safety door open
*Do not open the safety door when the
machine is in motion, in avoiding of electric
shock and injury.
Caution
*Please read all operation details before
further use of the machine. To use it in the
correct way and use it correctly.
*Open machine inside by authorized electricity
engineering person only and regularly inspect
and maintain the machine.
Total Power Information
*Voltage is 220V and Voltage Frequency is
50-60HZ/s. Make sure of it whether the total
power supply or not, or dangerous case will
occur.
Safety Pictograms

3
Precaution For Safe Use
·Strictly prohibits to move, damage, change or cover any warning symbols and
nameplates.
·Strictly prohibits to move, damage or change any protected equipment of the machine.
·Be sure to observe the following precaution to prevent operation failure, or adverse
effects on the performance and functions of the product. Without it may occasionally
result in unexpected events.
--Whether the machine is installed completely;
--Whether every part of the machine is adjusted well;
--Whether the total power connects and make sure of the using place;
--Check and confirm the protected equipment and security;
--Check to confirm the machine can be charged and the control system can work
efficiently with the manual book;
·Should turn off all switches including the total power and the gas processor when the
machine is off;
·This machine has Touch Screen and Program Controller, keep the main electric
cabinet clean and dry, strictly prohibits put anything into the electric cabinet, or serious
consequence will occur;
·Make sure of the gas pipe connect, or the machine cannot work normally and accident
will happen;

4
Adjust bag width
The bag magazine can be adjusted to suit for different premade bag size.
Adjusting Steps
Step 1: Loose the black handle.
Step 2: Turn the hand wheel ( show as on above picture), then put a bag into the bag
magazine and adjust both baffles to fit the bag width. When the hand wheel is turning,
Both baffles can be moved at the same time.
Step 3: After the bag width is fixed, then fasten the black handle.
Then bag width adjusting on the bag magazine is finished.

5
Running Mode
A. Continue Running Mode: When machine is on, it will be run for continue mode at first.
B. Manual mode: When machine is needed to changed for manual running, it had to be pressed
for the button of STOP for 2 SECONDS. Then the machine will be run step by step. It is good
for adjust the machine when the bag is changed.
C. Stop machine: It had to be pressed for the button of STOP for 1 SECOND. Then the machine
will be stop and the cylinder will be reset.
Use And Operation