SOUNDMASTER Highline UR8900 User manual

DEUTSCH NEDERLANDS
ENGLISH ROMÂNĂ
FRANÇAIS
UR 8950

ENGLISH
ENG 1
SAFETY
•Use apparatus only indoor.
•Do not use this apparatus near any water.
•Never open this apparatus. DANGER FOR LIFE !! RISK OF ELECTRIC SHOCK !!
•If cord or plug shows some damages, carefully unplug unit and bring to service centre.
•Do not block ventilation openings of apparatus. Min. 15cm free ventilation area all around apparatus.
•Unplug this apparatus during lightning storms or when unused for a long period of time.
•Change back-up battery every 12 month.
•Do not put empty battery into fire DANGER OF EXPLOSION !!
•For disposal or recycling of batteries or apparatus, please contact your dealer or local authorities
Technique
Power consumption 4 W
AC 230V 50Hz
Back-up battery 1pc 9V Block (Battery not incl.)
CONTROLS
1) SNOOZE
2) TIME / ALARM UP ▲
3) TIME / ALARM DOWN ▼
4) ALARM 1/2 SWITCH
5) TIME SET / ALARM OFF
6) ALARM 1/2 SETTING
7) BUZZER VOLUME LEVEL
8) DIMMER DISPLAY (LOW/MED/HIGH)
9) BATTERY COMPARTMENT
9

ENGLISH
ENG 2
Installation
Ensure you power supply have 230V 50Hz and connect plug to your wall outlet.
Battery back-up (battery not incl.)
Insert a 9V battery into compartment (9) in case of power failure. During power failure LED is OFF, but clock runs
internal and alarm time will be kept in memory. After power is back LED light up and clock return to normal mode.
Pay attention to insert battery in correct polarity !
Time set
Press and hold (5) SET TIME / ALARM OFF and set time with (2) ▲in fast speed forward. When you miss correct
time you can adjust with knob (3) ▼slowly backwards. After correct time is setted, you can release button (5)
Alarm set AL1/AL2
AL1: Press and hold AL 1 (6) and set alarm time with knobs (2) ▲and (3) ▼. After setting release button (5)
AL2: Same as AL1, just press and hold AL2 (6) instead of AL1
Setting alarm mode
Switch (4) in position:
OFF ÆNo alarm
AL1 ÆAlarm 1 activated (AL 1 icon shown in LED display)
AL2 ÆAlarm 2 activated (AL 2 icon shown in LED display)
AL1 + 2 ÆAlarm 1 + Alarm 2 activated (AL1 + AL2 icon shown in LED display)
Alarm off / Snooze function
•SNOOZE: After buzzer goes on to setted time press (1) SNOOZE
Alarm repeated again after 7-8 minutes
Thiscanberepeatedseveraltimes
•Alarm off and automatic activated for next day: Press (5) SET TIME / ALARM OFF
•Alarm off and NOT activated for next day: Switch (4) to pos. OFF
Buzzer sound volume
With switch (7) ALARM SOUND you can pre-select buzzer volume to LOW / MEDIUMl / HIGH level
LED Brightness
With switch (9) BRIGHTNESS you can adjust brightness LOW / MEDIUM / HIGH level
Technical changes without any further announcement
Copyright by Woerlein GmbH, 90556 Cadolzburg, www.woerlein.com