Spectra Precision UL633 User manual

UL633 – Quick Card
Manual Mode On/Off
5 + 8 change Y-slope
6 + 7 change X-slope
Press quickly – On
Press and hold 2 seconds-/Off
Bubbles flash during self-leveling.
If a grade value has been dialed in, the unit
starts the temperature- reference check
first - thermometer symbols flash
Rotation Speed / Scan mode
Quickly press and release to toggle
through the pre-selected rotation
speeds (0, 80, 200, 600, 900 rpm).
Press and hold for three seconds
changes the unit into scan mode.
When in scan mode, quickly press and
release button 4 toggles through the
pre-selected scan sizes (5, 15, 45, 90,
180°).
Starts the MENU entry
5 to 8 Up/Down; Left/Right
Change the Y- /X- slope in manual
mode. Navigate through the menu and
change values.
6 + 7 vertical direction alignment
Grade Entering mode
Step and Go or Digit Select (Default)
Spectra Precision Division
8261 State Route 235
Dayton, Ohio 45424-6383 U.S.A.
[phone] Phone

MENU Functions horizontal
Press button 1 to enter the menu
5 – 8 scroll through the menu - selected icon will be highlighted
4 opens the submenu OR starts the selected function.
3changes the unit back to the standard or previous display.
Automatic PlaneLok
Vertical
Horizontal
Automatic Axis Alignment
View Axis Angle
angle difference
between 2 points after
performing two axis
alignments in sequence
Automatic Grade Match
Select Standby
at the menu
4activates/
deactivates Standby
Spot Search - Manual Plumb Beam
Detection
4 - Fan beam active – red LEDS on
SF601 provide direction to the
center of the plumb beam

MENU Functions vertical
Press button 1 to enter the menu
5 – 8 scroll through the menu - selected icon will be highlighted
4 opens the submenu OR starts the selected function.
3changes the unit back to the standard or previous display.
Automatic Spot Align
SF601 guides the plumb
beam to the correct
direction point. Plumb
beam moves to the Z-grade
value after finishing the
alignment
Standard Display
Menu: IR -
controlled
If the radio connection will be disturbed,
the RC603 switches to IR-mode.
Menu: Radio -
controlled
Automatic Spot Match
Measures the grade value
between to points by
aligning the plumb beam
to the SF601’s center point
and switching back to
automatic Z-axis grade
mode while displaying the
measured Z-grade value.
Automatic SpotLok
Aligns and holds the
plumb beam
continuously
to the SF601’s center
point

Pairing UL with RC + HL750 Select Mask sectors
Settings
Enter the MENU with button 1 at the Standard Display and select Settings with button 4.
The Setting Menu offers the following functions:
Pairing Mask Mode Grade Entry Grade Display Sensitivity
HI-alert Information Password Password RF-Channel Select
Set On/Off Language
Select Step and Go or
Digit Select use 6/7;
confirm with 4
Select Percent, Permille or
Degree use 6/7;
confirm with 4
Select Sensitivity – Low,
Mid or High use 6/7;
confirm with 4
Select HI-alert – 5 min.,
30 sec. or HI-Off use 6/7;
confirm with 4
Edit User Info use 5/8 and
1/2; confirm with 4
Edit Passwort
use 1 to 8; confirm with 4
Select Password On/Off
use 6/7; confirm with 4