Spectra Precision HL760 User manual

Pairing two HL760
DRO Receivers
January 2015

Pairing HL760 + HL760
Before using one HL760 as a receiver and the second one as a
remote display, both receivers have to be paired. (required only
once for each device)
Identification code of the paired device is stored in memory.
Please follow the pairing steps on both receivers as shown on the
next slides.

Pairing HL760 + HL760
Turn on the receivers, then press and hold the Scroll up
and Scroll down buttons for two seconds.
After two seconds, the display on both receivers
shows MENU first, then RDIO
Press and release the Enter button –
the displays show the current radio mode
or or

Pairing HL760 + HL760
If not already set to HL, press Enter button,
then press Scroll up or scroll down button
until HL is displayed.
Press Enter (unit) button again to enter selection
then press the Scroll down button until PAIR
is displayed.
Press and release the Enter (unit) button
The display shows PAIR and a rotating bar
After completing PAIR, OK will be displayed

HL760: General Operation
Remote Operation
Turn both HL760’s Off.
The first HL760 turned on becomes the laser SENSOR
(receiver).
The second HL760 turned on becomes the REMOTE
DISPLAY / CONTROL PANEL
Turn on the HL760 that is desired to be the SENSOR
first.
Turn on the HL760 that is desired to be the REMOTE
DISPLAY / CONTROL PANEL second.
RMT.D –OK (flashing) will be displayed.
Press ENTER to operate this HL760 as the REMOTE
DISPLAY / CONTROL PANEL.
NOTE: If ENTER is not pressed, both HL760’s will
revert to standard operation.

HL760: General Operation
When working as a remote display, an antenna symbol is
permanently turned on.
During REMOTE DISPLAY / CONTROL PANEL operation,
RMT.D is displayed.
The Unit will remotely display the elevation readings of
the SENSOR, as long as the Antenna symbol shows the
two are within radio range of each other up to 100 meters
(330 ft).
The RMT.D unit can remotely adjust the Accuracy and
Units of Measure of the SENSOR.