Speed Queen ATGE9A Operator's manual

Quick Consumer
Manual

Installation
Parts included:
Welcome
Thank you for purchasing a Speed Queen®appliance. We value you as a customer.
At Speed Queen, leading performance is our daily reality. We seek to deliver an outstanding experience in every aspect of laundry.
Your machine was built to last 25 years in your home and Speed Queen support has been built to provide you with the best service in
the industry.
Two (2) lter
screen washers
Two (2) plain
rubber washers
Four (4) rubber
feet
Beaded strap Three (3) screws
(electric models)
Two (2)
ll hoses
Two (2) plugs
2. Remove shipping materials.
• Remove lower panel (2 screws)
• Remove four (4) bolts securing shipping brace. Remove
brace and blue label
• Remove two (2) bolts from rear of washer
• Insert two (2) plugs into rear bolt holes
• Reinstall panel
3. Connect ll hoses – water pressure = 20-120 psi
[138-827 kPa].
• Flush water supply lines
• Use two lter screen washers with screen facing tap
• Use two rubber washers in end of hose connecting to
the machine
4. Connect drain hose to drain receptacle – 36 in. [91 cm]
recommended height.
• Use beaded strap to secure drain hose to drain
receptacle
1. Move unit to area within 4 ft (1.2 m) of nal installation.
5. Gas models – connect gas supply pipe.
Gas service to a gas dryer must conform with the local codes
and ordinances and be connected by a licensed professional.
Refer to installation instructions, which can be found at speedqueendoc.net
• Tighten all connections securely but do not overtighten
to avoid breaking or bending the gas valve bracket
Turn on gas and check all pipe connections (internal and
external) for gas leaks by applying a non-corrosive leak
detection uid to the ttings. If bubbles are present then
a leak is likely.
Retighten connections and recheck for leaks.
4.
5.
2.
3.
2.
(gas connection)
(water connection)
(drain connection)

6. Connect exhaust system.
• Dryer must be exhausted to the outdoors
• Use 4 in (102 mm) rigid duct
• Maximum straight duct length = 65 ft (19.8 m). Each elbow
deduct 10 ft (3 m)
• Sucient make-up air must be supplied. The free area of any
opening for outside air must be at least 40 in2 (25806 mm2)
per unit
7. Position and level the unit.
• Recommended rear clearance minimum is 2 in (51 mm) for
utility connections and 6 in (152 mm) when venting through
rear of unit
• Tighten locknut after nal adjustment
• Place four (4) rubber feet on leveling legs
• Unit must not rock
Installation (continued)
8. Wipe out inside of washtub and dryer drum.
9. Connect washer and dryer to electrical power – on individual
branch circuit. Refer to serial plate for electrical ratings.
10. Run washer through one complete cycle to make sure it is
operating properly and properly leveled.
11. Check for leaks.
12. Start dryer and check that dryer is heating.
7.
(dryer)
9.
8.
8.
10.
12.
6.
(washer)

1. Prepare laundry 2. Add high eciency 3. Load laundry 4. Close door 5. Set cycle
(he) laundry supplies* 10 kg maximum
loading capacity
6. Set temperature 7. Set spin speed 8. Set soil level 9. Press start/pause
Operating
5.
6.
7.
8.
9.
Washer
*Note: Pods must be placed in washtub with laundry.

5. 6. 9.
7. 8.
1. Prepare laundry 2. Clean lint lter by wiping 3. Load dryer half 4. Close door 5. Turn on dryer by
lint out of screen area full with laundry pressing power/cancel
9 kg maximum
loading capacity
6. Set cycle 7. Set temperature or 8. Set dryness level 9. Press start/pause 10. Remove laundry from
fabric selector dryer once cycle has ended
Operating
Dryer

Download full documentation and view installation and operating
videos for an immersive experience at Speedqueendoc.net or
scan the QR code below.
If you wish to receive printed documents at no cost, please
complete the order form and return by mail to the address below,
or email your request to [email protected].
Alliance Laundry Systems
Technical Communications
Shepard Street
P.O. Box 990
Ripon, WI 54971
United States
Order Form for
Printed Documentation
Model No.
Serial No.
Name
Address
Phone No.
Email Address
✂
Part No. 807604
May 2019
© Published by permission of the copyright owner –
DO NOT COPY or TRANSMIT
Speed Queen by Alliance Laundry Systems