SpeedyBee Bee 35 User manual

SpeedyBee
Meteor LED Strip
User Manual
Contents
1. LED Strip Wireless Conguration
2. FC Wireless Conguration
3. BOOT Mode
4. Bee35 Meteor LED Installation Instructions

The Meteor LED features an integrated wireless conguration
module, enabling easy setup and adjustments via the
SpeedyBee APP for your drone.
The Meteor LED is facto-prepared with pre-soldered LED strips
for your convenience.Follow the detailed installation steps provided
in the sections below.
The Bluetooth conguration module is set by default to
automatically turn o the Bluetooth conguration function one
minute after power is supplied
(the timer does not count during the conguration).
After the connection is disconnected, it will sta a new one-minute timer.
BEC has a red indicator light as the power indicator,
which stays on after power is supplied.
The rst LED on the light strip sees as the Bluetooth status indicator:
Solid green: Bluetooth is connected.
Flashing green: Bluetooth is not connected.
Green light o: Bluetooth is turned o.

LED Strip Wireless Conguration
If the ight controller comes with a built-in Bluetooth
conguration feature, there is no need to solder TX and RX. You only
need to connect V and G to peorm wireless conguration of the LED.
G V T R B
① The red wire should be soldered to the BAT pad of the ight controller
or the positive pole of the power cable, with an input voltage range
of 2-6S lithium batte.
② The black wire should be soldered to the G pad of the ight controller
or the negative pole of the power cable.

FC Wireless Conguration
This feature is for ight controllers without Bluetooth conguration
capabilities, with specic soldering instructions as follows.
①Solder the red wire to the BAT pad on the ight controller or to the
positive pole of the power cable. The input voltage range should be
for a 2-6S lithium batte.
② Solder the black wire to the GND pad on the ight controller or to
the negative pole of the power cable.
③ Find a set of unused UART on the ight controller. Solder the yellow
wire to the RX pad of the UART and the white wire to the TX pad
of the UART. For example, using UART 1.
④ Connect the ight controller to the congurators on the computer.
Navigate to the pos page, enable the MSP for the relevant UART
connected to the Meteor LED, and set the baud rate to 115200.
Then click 'Save and Reboot' in the bottom right corner.
G V T R B
⑤ With all soldering and settings complete, power up the drone and
open the SpeedyBee APP. Click the plus sign at the bottom,
select 'SpeedyBee MeteorLED'. Once connected,
click on 'FC Tuning' for wireless Conguration.

BOOT Mode
Operation:
① Press and hold the BEC button rst.
② Power up the drone.
③ Plug in the USB to enter DFU mode.
The Meteor LED can is used to enter DFU mode on the ight controller
through the button on the BEC module. It only suppos
ight controllers with BOOT solder pads, such as the
SpeedyBee F4mini ight controller.
G V T R B

Bee35 Meteor LED
Installation Instructions
M3*18
M2.5*8 self-tapping screw