SpiroTiger STGO Instruction manual

1. Starting
Assembly
Place the pieces, as shown below, on the table.
1. Place the valve piston 1into the V-Tube 2as shown
and secure it into place using the screw fastening 3
(small opening).
2. Place the V-tube 2into the handheld device 4.
3. Place the mouth tube 5into the V-tube 2and fasten
it using the second screw fastening 6(large opening).
4. Place the respiration bag 7on the open end of the
V-tube 2and the mouthpiece 8on the opening end of
the mouth tube 5.
Turning on
Press the Enter key for at least two seconds.
Turning o󰀨
Press the Enter key for at least three seconds. If not
used the device automatically shuts o󰀨 after ve minutes.
2. Set-up
Entering training duration, respiration rate, and bag size
After the device has been turned on press the key until the
desired symbol starts to blink.
WATCH for training duration
FREQUENCY for respiration rate
BAG for respiration bag size
Select with the and keys the desired value and conrm
it using the Enter key .
Setting ranges
• Training duration: 0 - 99 minutes
0 (zero) equals no xed training duration.
• Respiration rate:
15 - 60 breaths per minute
0 (zero) respiration rate means no given breathing pace.
• Respiration bag size: 0,5 to 5,0 litre
Respiration bags are labelled with their size.
The respiration bag size has to be individually
determined for every user.
Screw fastening
with small opening 3
Individual
respiration bag 7
Handheld device 4
Mouth tube 5
Mouthpiece 8
6
V-tube 2
Valve piston 1
Screw fastening
with large opening
This document does not replace any other provided measures necessary for the operation/usage of this device. Read before
using the SpiroTiger®device the detailed instructions of the user manual! The complete manual can be downloaded from:
www.idiag.ch - Application, Downloads, SpiroTiger Sport, Handbücher
Battery compartment
User‘s Quick Guide
STGO EN
idiag AG, Mülistrasse 18
CH-8320 Fehraltorf
Tel. [phone]
Fax [phone]
[email protected]
www.idiag.ch

Pause
If the valve does not move for more than 10 – 15 seconds
the device will switch to P(Pause) mode. This means the
training has been interrupted. Reasons for this could be: the
respiration is to shallow or the respiration bag is too big. To
continue the training, just start breathing into the device
again. If the training is not continued within 5 minutes, the
device interrupts the training and returns to the start menu.
Failure notice / Alarm (AL)
In a case of repeated disregard of training notices the de-
vice will automatically shut o󰀨 and displays AL as an abbre-
viation of „alarm”.
• After 30 seconds the device resumes the training automa-
tically.
• In case the device consistently shuts down due to alarms,
• then a possible device set-up change may have to take
• place.
• The acoustic alarm can be turned o󰀨 by pressing the
Enter key .
End of training
At expiration of the entered training duration or after an
interruption of the training by pressing Enter , the device
shows the following training results of the most recent trai-
ning:
(With you switch through the logbook)
Number of training, duration of training , average respira-
tion rate , bage size , total ventilation volume VT and
average minute respiration volume VM.
The date are saved in the logbook.
Press the Enter key to return the the start menu.
3. Training
Starting a training
Turn on the SpiroTiger®. Start the training by pressing the Enter
key .
Respiration rate
Training time
(minutes : seconds)
The SpiroTiger® indicates every change from inspiration to
expiration with a short sound and change of the side of the
running arrows.
Place the mouthpiece in your mouth, take
a deep breath and start with the expiration
when the running arrows begin to move
upward.
When you hear the short sound start
breathing in. The running arrows are now
moving downwards.
Important: When a 0 (zero) respiration rate is selected only
the inspiration and expiration circles are indicated ( / ).
Training can take place at a completely self determining pace.
The training supervision remains active. At the end of the
training a respiration rate average is given and the total
respired volume.
Displays and messages during the training
During the training the device supervises the respiration
depth.
Optimal respiration depth
Breathe shallower!
Increase with the arrow the respiration
rate, or increase the bag size.
Breathe deeper!
Reduce with the arrow the respiration
rate, or decrease the bag size.
If the given pace is not maintained, the speed arrows appear:
Breathe faster! Breathe slower!

19.04.2017
4. Cleaning, Maintenance
For personal use the air leading pieces (user set), with the
respiration bag as an exception, can be cleaned in the
dishwasher. The respiration bag has to be cleaned manually
and then hung up to dry with the opening facing down-
wards. If multiple persons are using the same user set it
must be disinfected (though boiling or sterilization see
Hardware User Guide, chapter «Cleaning and
Disinfection»).
Cleaned in the Cleaing only by
dishwasher and hand
though boiling
Respiration bag and mouthpiece must be regularly replaced
as a hygienic safety precaution.
Device and Multiple Users
For hygienic reasons we suggest the use of a personal
mouthpiece and respiration bag or the use of a completely
personalized user-set.
5. Storage
• Store the SpiroTiger®dry, dust free environments only.
• For storage only use the original packaging.
• For further information see the Hardware User Guide.
• For storage remove the batteries.
• Further information: please see complete manual
6. Important Security Advice
• The SpiroTiger®should only be used for athletic, wellness
and sport orientated purposes.
• If you have any health concerns, training is only allowed
with the consent of a doctor.
• idiag does not take any responsibility for the e󰀨ects of
medical or therapeutic use. idiag is not liable for any side
e󰀨ects following SpiroTiger®training.

Battery compartment
Handheld device
Mouth tube
Mouthpiece
Screw fastening
with large opening
V-tube
Valve piston
Individual respirator-bag
Screw fastening
with small opening