Sport-thieme Pro User manual

Sport-Thieme®„Pro“
Football Training Rebounder
Assembly instructions
Art.-Nr.: 247 1701
0218214 · © 2018 Sport-Thieme GmbH
D-38367 Grasleben ·Germany
sport-thieme.com · info @sport-thieme.com
Phone: [phone] · Fax: [phone]

2
Assembly instructions for Art.-Nr. 247 1701
List of parts:
- 1 frame A (with 2 x 3 hand wheels as xing points)
- 1 frame B (with 2 x 2 hand wheels as xing points)
- 2 aluminium bars, length 500mm
- 2 aluminium bars, length 860mm
- 104 net holders
- 2 nets with elastic rope
Assembly:
The equipment is nearly completely mounted so that only a few steps are necessary. 3 basic positions are provided for the use of
this equipment.
Mount the equipment on a smooth surface so that mitres are at the top. Push mitres together (factory setting). Now fold apart
both frames of the equipment as far as it will go.
Release hand wheels inside the frame to remove the bars.
Before assembly x at rst both nets at the frames. Bend open net holders a little and press the elastic cord of the net into the
eyes.
Distribute net holders as follows:
- 15 each at the long sides
- 11 each at the short sides
After having mounted all net holders x net at the goal
construction. Stick net holders in the net hook rail and
x them with a 90 degrees’ rotation. If necessary use
a thin screw driver. Dismantling of the net is done in
reversed order.

3
Assembly instructions for Art.-Nr. 247 1701
Basic position 1:
Hook slotted holes of the short bars
(length 500mm) into the following
slightly released hand wheels:
- frame A: hand wheel 2
- frame B: hand wheel 1
Then tighten all hand wheels.
Basic position 2:
See basic position 1 but the whole
equipment is upended on the short
sides.
Basic position 3:
Separate both frames by removing the short bars and pull apart the
mitres. Mount short bars (length 500mm) at
- frame B: hand wheel 1
and fold them up until they adjoin the upper long frame prole. Now
mount the other end of the short bars (length 500mm) at
- frame A: hand wheel 1
Now frame A is put straight and frame B canted. Then
mount the long bars (length 860mm) at the following
positions:
- frame A: hand wheel 3
- frame B: hand wheel 2
Finally tighten all hand wheels.
Check all fastenings from time to time! Do no climb nets and frames! If necessary tighten the
net rope again and knot it well!