4
1. First, open all boxes and remove all contents and parts (Figure 1). The
4 lights are fully assembled.
2. Set aside the two tripod pieces for later assembly.
3. elease the back side of the case from the velcro fastening. Remove the
backdrops.
4. Next, convert the carry case into a tent by
unfolding the white interior sides of the
tent and setting upright (Figure 2). Attach together with the velcro
strip in the corner where the two pieces meet.
You will now have a three-sided tent.
Flip the tent over so that the open side is
on the bottom and the black case side is
on top (Figure 3). Tuck the case flap
between the case and the tent material.
5. Attach a background to the tent by using
the built-in velcro strip on the colored
background to join with the velcro on the
tent’s interior top back crease (Figure 4).
6. Setup the lights by pulling down on the
stands and folding out the extensions
(Figure 5). Adjust the light heads by first
loosening the knob beside them,
repositioning and then re-tightening the
knob.
7. Assemble the tripod by first opening and
expanding the black, adjustable base of
the stand. Next, unscrew the securing
knob of the silver shaft and feed it through the base and screw it
into the silver shaft and tighten (Figure 6).
Shine lights through tent walls to diffuse light.
Tuck carry case flap under, between the top tent fabric and itself, to avoid
photographing it accidentally.
Tripod is adjustable at its base, at the camera stem, and will also expand
in height.
Do not put backgrounds in dryer or iron with a hot iron! This may
damage fabric...remove any creases by pressing with a cool iron.
Copyright 2016 DTX International
Figure 1
Figure 2
Figure 6
HELPFUL TIPS
Figure 5
Figure 4
Figure 3
Table Top Deluxe 24”
