To create a script press the Plus symbol in
the top right of the welcome screen.
Inserting a Script
On the Edit Document screen input a title
for your script. Type or copy your script into
the Document Text box.
Setup
Navigate to the prompting settings menu. If you
are using your iPod/iPhone in conjunction with a
teleprompter, set the mirrored display to ‘Yes’. If
you are using your device in straight-reading
mode, set the Mirrored Display settings to ‘No’.
Scrolling Speed - Set the default speed at
which your script scrolls. Note:
A ‘Scrolling
Speed’ of 5 is recommended for most users
when using a remote control.
Slow and Fast Time -
The speed of the script can be fine tuned
by utilising the ‘Slow Time’ and ‘Fast Time’
options. The ‘Slow Time’ and ‘Fast Time’
options allow you to input the slowest and
fastest times that it takes the ‘Talent’ to
read one screen of text. For example if at
the given font size the ‘Talent’ takes
between 3 and 5 seconds to read a
complete screen of text you can then set
the ‘Slow Time’ to 3 and ‘Fast Time’ to 5,
then any adjustment to speed made with
the remote control will be increments
between these two speeds.
Auto Start - This setting will start the script
scrolling as soon as it is opened.
Start Delay - Set a delay before the script
begins to scroll upon opening.
Break Marker - Break Markers are
characters embedded into your script
that you can use to jump to certain points
in your script. The default marker is ‘*#’.
To jump between break markers pause
the script using the remote, you can then
use the forward and rewind buttons to
scroll through the break markers.
Remote Type - If you are using a wired
controller set the remote type to Wired.
When using the wireless control, set the
remote type to Wireless V2.
Other Settings
