SSANGYONG Actyon 2012.12 User manual

0-3
0000-00
1. DIMENSIONS Unit: mm
Top view
Side view
Front view Rear view

0-4
2. SPECIFICATIONS

0-5
0000-00

0-6
Vin Label Certification Label
Chassis NumberEngine Number (G23D)
3. VEHICLE IDENTIFICATION
Engine Number (D20DTR)
The engine number is stamped on the
upper rear left-hand side of the cylinder
block.
The chassis number is stamped on the
frame behind the front right tire.
The engine number is stamped
on the lower area of cylinder
block behind the Intake
manifold.
The certification label is located on
the driver’s door sill.

0-7
0000-00
4. MAINTENANCE INTERVAL
1) Diesel Engine - EU

0-8

0-9
0000-00

0-10
2) Diesel Engine - GENERAL

0-11
0000-00

0-12

0-13
0000-00
3) Gasoline Engine

0-14

0-15
0000-00

0-16
5. RECOMMENDED FLUIDS AND LUBRICANTS
Use only Ssangyong recommended fluids and lubricants.
Do not mix any different types or brands of oils or fluids. This may cause damages.
Keep the specified levels when adding or replacing the fluids.
-
-
-

0-17
0000-00
6. JACK-UP POINTS

0-18
7. PIN ARRANGEMENT OF DIAGNOSTIC CONNECTOR
1) Functions of Terminal
It is installed under the instrument panel and consists of 16 pins
Pin no. 1
Pin no. 2
Pin no. 3
Pin no. 4
Pin no. 5
Pin no. 6
Pin no. 7
Pin no. 8
Pin no. 9
Pin no. 10
Pin no. 11
Pin no. 12
Pin no. 13
Pin no. 14
Pin no. 15
Pin no. 16
-
-
STICS "C1"
Ground
Signal ground
CAN - HIGH
Engine ECU
ABS/ESP UNIT "2"
AIR BAG UNIT "9"
-
TCU "B12" (6-AT)
"A18" (5-AT)
-
TCCU "21"
CAN - LOW
STICS "B21"
Battery +

0-19
0000-00
8. ELECTRIC COMPONENTS AND LAYOUT
1) Wiring Harness Arrangement

0-20
2) Components Locator

0-21
0000-00
9. STANDARD BOLTS SPECIFICATIONS

0-22
Metric bolt strength is embossed on the head of each bolt. The strength of bolt can be classified as
4T, 7T, 8.8T, 10.9T, 11T and 12.9T in general.
Observe standard tightening torque during bolt tightening works and can adjust torque to be prope
r
within 15 % if necessary. Try not to over max.
allowable tightening torque if not required to do so.
Determine extra proper tightening torque if tightens with washer or packing.
If tightens bolts on the below materials, be sure to determine the proper torque.
1.
2.
3.
4. Aluminum alloy: Tighten to 80 % of above torque table.
Plastics: Tighten to 20 % of above torque table.
1)
2)