Stanley ST-12L-DH-E User manual

/LJKW,QGXVWULDO'HKXPLGL¿HU
ST-12L-DH-E / ST-16L-DH-E / ST-20L-DH-E

© 2013, Pinnacle Products International, Inc.
Read The Instruction manual: When this symbol is marked on a product, it
means that the instructon manual must be read.
ENGLISH

© 2013, Pinnacle Products International, Inc.
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Starting the Dehumidifier:
1. Connect the dehumidifier to the proper
electrical power.
2. Press power button to turn on the unit.
3. The digital display will show the ambient
humidity in the room.
4. Choose fan speed: +/í
5. Choose desired humidity setting, Continuous
(CO) or Automatic (AU).
Humidity Settings:
Continuous Mode (CO)
– Continuous mode will keep the relative
humidity at the chosen constant point.
– The setting range is from 50%-80% relative
humidity.
– When the ambient humidity is 3% lower than
the chosen humidity setting, the compressor
will stop.
– When the ambient humidity is 3% higher than
the chosen humidity setting, the compressor
will re-start and maintain the chosen humidity
setting.
Automatic Mode (AU)
– Automatic mode will keep the ambient
humidity constant in relation to the ambient
temperature of the space.
– When the ambient temperature is lower than
5 ºC, the compressor will shutdown while the
unit remains on.
– When the ambient temperature is between
5 ºC and 20 ºC, the space will be kept at 60%
relative humidity automatically.
– When the ambient temperature is between
21 ºC and 27 ºC, the space will be kept at
55% relative humidity automatically.
– When the ambient temperature is higher than
28 ºC, the space will be kept at 50% relative
humidity automatically.
Operation
Continuous Mode Display Automatic Mode Display

© 2013, Pinnacle Products International, Inc.
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Operation
Timer:
– The timer can be set for 1-24 hours.
– The timer can turn the unit it on while in
standby mode or turn the unit off after a
period of use.
Automatic Start
– With the dehumidifier plugged in but powered
off (Standby Mode), press the timer button
until the desired time is displayed. (1-24
hours)
– The display will flash 5 times and the timer
will be set. The unit will turn on in the
displayed amount of time.
NOTE: Pressing the power button when the
timer is set will cancel the timer and power
on the unit.
Automatic Shutdown
– With the dehumidifier plugged in and
operating, press the timer button until the
desired time is displayed. (1-24 hours)
– The display will flash 5 times and the timer
will be set. The unit will continue to run for the
displayed amount of time.
– Once the time limit is reached, the unit will
shut down.
NOTE: Pressing the power button when
the timer is set will cancel the timer and
shutdown the unit.
OPERATION
LOW
HI
POWER
SPEED
TIMER
HUMIDITY
SETTING
TIMERTANK FULLDEFROST
Power
Fan Speed
Timer
Humidity Setting
Tank FullDefrost
Digital Display
Unit will power on in 3 hours Unit will shutdown in 3 hours

© 2013, Pinnacle Products International, Inc.
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Maintenance
Draining:
Water Tank Draining
– The condensed water will drain into the tank
in the rear of the dehumidifier.
– When the tank is full, the tank full indicator
light will illuminate.
1. Turn off the dehumidifier.
2. Remove and empty the water tank
3. Replace the tank and power the
dehumidifier on.
Continuous Draining
– The dehumidifier can be configured to drain
continuously with a piece of PVC tubing
NOTE: PVC tubing NOT included with this unit.
1. To install PVC tubing, remove water
tank and plug tubing into drain hole.
2. Replace the water tank in case tubing
becomes dislodged.
3. Be sure to place drain tube at a lower
point than dehumidifier to ensure proper
draining and water flow.
Filter Cleaning:
1. Remove the water tank before removing filter
2. Remove filter by pulling down on filter tabs.
3. Wash filter with cool water only, DO NOT use
cleaning solvents or alcohol.
4. Air dry filter before replacing and using
dehumidifier.
NOTE: Clean filter once every two weeks of
operation.

© 2013, Pinnacle Products International, Inc.
NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
RISK OF ELECTRIC SHOCK! DISCONNECT FROM POWER BEFORE MAINTENANCE.
WARNING
Plug Replacement
NOTE: This section only applies to heaters sold or used in Great Britain.
This appliance is supplied with a BS1363 3 pin
SOXJ¿WWHGZLWKDIXVH6KRXOGWKHIXVHUHTXLUH
replacement, it must be replaced with a fuse
with the proper amp rating. (see Technical
6SHFL¿FDWLRQVSDJHDQGDSSURYHGWR%6
In the event the mains plug has to be removed/
replaced for any reason, please note:
IMPORTANT: The wires in the mains lead are
colored in accordance with the following code:
Blue – Neutral Brown – Live
Green/Yellow – Earth
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows:
The blue wire must be connected to the terminal
marked with an N or colored black. The brown
wire must be connected to the terminal marked
with an L or colored red. The green/ yellow wire
must be connected to the earthing terminal which
is marked with an E or with the earth symbol.
127(,IDPRXOGHGSOXJLV¿WWHGDQGKDVWR
be removed take great care in disposing of the
plug and severed cable, it must be destroyed to
prevent engaging into a socket.
Never connect live or neutral
wires to the earth terminal of
the plug.
WARNING
GREEN / YELLOW
Earth
BROWN
Live
FUSE
3 Amps
CORD CLAMP
BLUE
Neutral
Plug Replacement Wiring Diagram
Figure 3

Stanley and are registered trademarks of the Stanley Black and Decker,
,QFRULWVDI¿OLDWHVDQGDUHXVHGXQGHUOLFHQVHE\3LQQDFOH3URGXFWV,QWHUQDWLRQDO,QF
Pinnacle Products International, Inc.
Yardley, PA USA
www.pinnacleint.com
© 2013 Stanley Black & Decker, Inc.