Stanley PAC iEVO Series User manual

Access Control |PAC iEVO Finger rint Reader Series
Overview
The Stanley PAC iEVO Fingerprint Reader series of advanced fingerprint readers elevate iometrics recognition from limited use to universal acceptance.
When restricting access, a fingerprint is a one-of-a-kind solution that cannot e guessed, forgotten, stolen, shared or re-created.
The readers utilize Multispectral Imaging, a technology that has a proven track record involving millions of users and one that always works in real world
conditions. A ‘hidden’ internal image of a fingerprint exists far elow the surface of the skin. The readers simultaneously capture an image of oth the
surface and su surface ‘internal fingerprint’ to capture clear, clean images every time - even when surface features are a sent or hard to distinguish due to
age, dirt, finger pressure and skin or environmental conditions. The sensor is also a le to identify whether the fingerprint is genuine or a fake/spoof.
The Ultimate Reader can e installed externally, it is uilt to ensure long lasting dura ility regardless of weather conditions, accidental damage or physical
attack. The reader is wired to a Control Board that is installed on the secure side of the door, this leaves nothing at the reader to compromise door
security.
Users are enrolled within the Stanley PAC software, eliminating the need for a separate application. The finger to e enrolled (up to ten) is selected, and
after it has een added the fingerprint data is sent to all the other PAC iEvo readers via its LAN connection. The Stanley PAC software stores the
fingerprint against the cardholders record, confirms a presented fingerprint and passes the access authorized command to the PAC 512 Access Controller,
which opens the door.
Key Features
Compatible with all Stanley PAC Access Software Editions
Enables high throughput, identification in < 1 second
Maintains performance in rain, cold, dry, hot environments bright sunlight ot dark
conditions. Even when the finger is covered with Vaseline or wearing a Latex glove.
Images surface and subsurface fingerprint features using patented multispectral
imaging technology
The Control Board is mounted in environmentally protected secure side of the door
High durability glass platen with no coatings that wear out
Standard liveness detection to insure only genuine fingers can be matched
Operates across wide ranges of temperature, relative humidity, and ambient light
PAC Format support fpor Stanley PAC512-series Door Controllers
enables easy installation with low cost 22AWG Unshielded 4-conductor cable
Suitable for indoor and outdoor use (Micro - Indoor only)
equires minimal maintenance
MICRO
Mullion Mountable
ULTIMATE
Internal or External Use

© Copyright 2016, Stanley Security Solutions, Inc. All ights eserved. The information contained herein is subject to change without notice. Stanley shall not be liable for technical or editorial errors or omissions contained herein.
Stanley, PAC, Stanley PAC, One-Touch are registered trademarks of Stanley Security Solutions, Inc. eadykey is a registered trademark of Stanley Security Solutions, Inc in the European Union,
UK and Australia and of Bosch Security Inc. in the USA. All other trademarks are the property of their owners. ev. AJM8/13
Visit us at...
Dry Wet Dirty
No
Image
Elderly High levels of
am ient light
Other
Biometric
Readers
No
Image
Serial No.
Model No.
PACPart No.
12V BATTERY
SEALEDRECHARGEABLE LEAD-ACID BATTERY
RX
CTS
TX
DTR
0V
PAC iEVO
CONTROL BOARD
PAC iEVO
READER
DOOR
LOCK
EXIT
BUTTON
HOST PC
LAN/WAN
12/24V 5V
LEDDC RTE
STATUS ONE
TOUCH DOOR2
2
DOOR1
1
LEDDC RTE
TX RX TX RX
IN OUT
NET
PORT
NET
TERM
ADMIN
PORT
READERDATA
LOCK1
30V; 3 A
THERMAL
FUSE
DOOR1
LOCK2
30V; 3 A
THERMAL
FUSE
RELAY2
30V; 5A
ACCESSPOWER
TCP/IP
RS-485
OVRD
TAMP
0V
N0
NGND
N1
SIGA
SIGB
0V
DC
RTE
I/P
LED
+V
DO
D1
RELAY1
30V; 5A
NC
NO
COM
NC
NO
COM
NC
NO
COM
NC
NO
COM
VIN
0V
MSTAT
LOCK
0V
0.2A MAX
INPUT:10.5-28.0VDC;
0.22A
(CONTROLLER + 4 READERS)
DOOR2
SIGA
SIGB
0V
DC
RTE
I/P
LED
+V
DO
D1
0.2A MAX
One-Touch™Testing
ToenterView Mode press the One-Touch
buttonmomentarily. Toe nter Active Mode
pressand hold the One-Touch button
for2 to 4 seconds. To leave One-Touch
testing,press the button momentarily
again.Note that One-Touch Active mode
willautomatically time out after 1 hour.
Fordetails of One-Touch modes see the
enclosedQuick Start Guide .
Thisdevice complies with Part 15 of
theFCC Rules. Operation is subject
tothe following two conditions: (1) this
devicemay not cause harmful
interference,and (2) this device must
acceptany interference received,
includinginterference that may cause
undesiredoperation
CAUTION- FIXED INTERNAL BATTER Y
Seemanual for disposal of unit.
Madein UK
AC 512 IP Mk. 2
Access Controller
ModelNo.
ManufactureDate
TOUCH READER
SIGNALVOLTAGE
FEATURES AND SPECIFICATIONS CHART
PAC iEVO MICRO PAC iEVO ULTIMATE
Desc iption Indoor Biometric
Fingerprint Reader
Indoor/ Outdoor Biometric
Fingerprint Reader
CPU ARM9 ARM9
Memo y RAM 16mb FLASH 32mb RAM 16mb FLASH 32mb
False Rejection Rate < 0.1% < 0.1%
False Acceptance Rate < 0.00001% < 0.00001%
Identification Speed < 0.2 sec < 0.7 sec
Template Capacity 1:N 8000 1:N 8000
Log Capacity 200,000 200,000
Voltage 12 VDC 12 VDC
Cu ent D aw < 400mA < 600mA
Reade Output Fo mat AC AC
Communication TC /I TC /I
Ope ating Tempe atu e 32° to 140°F -4° to 158°F
IP Rating - I 65
Powe Indicato LED in iezo Button LED in iezo Button
Ce tifications CE, FCC, RoHS CE, FCC, RoHS
Dimensions W: 1.77 x H: 4.13 x D: 1.97 in.
Surface
W: 2.99 x H: 5.39 x D: 3.66 in.
Flush
W: 4.69 x H: 6.02 x D: 1.85 in.
O de ing Info mation SBN# 46917 SBN# 46916
STANLEY PAC INTEGRATION
Seamlessly Integrated Fingerprint Enrollment
MULTISPECTRAL TECHNOLOGY REAL-WORLD COMPARISON
AC 512I TWO-DOOR CONTROLLER
One door shown for illustrative purposes only
This manual suits for next models
2
Other Stanley RFID System manuals