Star Trac E Series Use and care manual

Service Menu
STAR TRAC FITNESS 1 635-4113 Rev: A
Calibration & Setup: Touchscreen Calibration
E Series Treadmills: E-TRe & E-TRxe
The following procedure will guide you through the Touchscreen calibration of the E Series E-TRe and E-TRxe treadmills.
Step 1
Start on the default screen (Fig. 1)
Fig. 1
Step 2
Press and hold the VOL ‘+’ key and the CH ‘+’ key and the number ‘3’
key on the keyboard at the same time to enter the Service Menu (Fig.
2).
VOL
CH
Step 3
Press the number ‘5’ key on the keyboard or touch “Calibration Setup”.
Fig. 2

Service Menu
STAR TRAC FITNESS 2 635-4113 Rev: A
Step 4
Enter the Password “2 1 8” and press ‘OK’.
Fig. 3
Step 5
Press the number ‘5’ key on the keyboard or touch “Touchscreen Cal”.
Fig. 4
Step 6
Once in Touchscreen Calibration Mode you will see a grey box with
red notes on the left side of the screen.
DO NOT TOUCH THE SCREEN UNTIL DIRECTED
DO NOT TOUCH THE SCREEN WITH ANYTHING
OTHER THAN YOUR FINGER TIP
USE ONLY ONE FINGERTIP
DO NOT HIT THE SCREEN…USE A GENTLE TOUCH
Fig. 5

Service Menu
STAR TRAC FITNESS 3 635-4113 Rev: A
Step 7
•Turn the power off using the power switch
•Wait AT LEAST 30 seconds before turning back on
When prompted, touch the screen on the crosshair (Fig. 6)
Note: The crosshair will appear on the screen three times in different positions each time
Fig. 6a
Fig. 6b Fig. 6c
Step 8
Test unit for proper function.