Stealkey Customs Lian Li O11D Mini MK1 User manual

1
PNr.: LI011DMMK1
EAN: 4260754980089
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions

2
1. PREPARATION - WATER LOOP PLANNING
Have a look at the port overview and plan your water loop accordingly.
RADIATOR OUT
GPU IN
CPU OUT
FILL
FRONT
GPU OUT
RADIATOR OUT
RADIATOR IN
DRAIN
RADIATOR IN
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions
BACK
CPU IN

3
2. PACKAGE CONTENTS
WARNING - This product is intended for advanced users. Improper installation may
result in damage to your equipment. While all eorts have been made to provide the most
comprehensive information possible, Stealkey Customs assumes no liability expressed
or implied for any damage(s) occurring to your components as a result of using Stealkey
Customs cooling products, either due to mistake or omission on our part in the below
instructions, or due to failure or defect in the Stealkey Customs cooling products. Do
not disassemble the water block. Warranty will be voided. Turn on the power to your
system and discharge your body’s static electric charge before proceeding with the
installation procedure. If you do not feel comfortable with performing the installation
procedure, consult a qualied computer technician.
Mounting Screws Lian Li O11D Mini MK1 - Acryl
RGB Cable
6x M3
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions
1x D-RGB 3pin
(500mm cable)
RGB cable

4
INSTALL THE DISTRIBUTION PLATE
Install the Distribution Plate on the radiator grid of the chassis. Use the 6 included M3
screws. Do not overtighten the screws (Max 3-5 N/m).
3.
FRONT
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions

5
INSTALL THE DISTRIBUTION PLATE
Install the Distribution Plate on the radiator grid of the chassis. Use the 6 included M3
screws. Do not overtighten the screws (Max 3-5 N/m).
3.
BACK
2x M3
2x M3
2x M3
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions

6
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions
CONNECTING THE D-RGB CABLE
Connect the D-RGB cable to a compatible motherboard.
4.
INSTALLING THE CONNECTIONS
Mount the connections with G1/4 thread and close the remaining connections with
sealing plugs. Always perform a leak test before applying power to the system compo-
nents (max. 0.5 bar).
Align the screw positions.
Carefully loosen the shut-o valve of the filling connection to allow trapped air to
escape.
5.
CLEANING & CARE
Clean the manifold plate only with microfiber cloths to avoid scratches in the material.-
Do not use cleaners containing alcohol to avoid stress cracks in the material.Before
installing the manifold plate, it is recommended to rinse the manifold plate to remove
any last residues. Acrylic paints can leave residues.
6.

320
65
71
93
122
189.75
215.25
255
283
20
18
28
162
105
110
120
60 30
55
50
105
79
7
DISTROPLATE DIMENSIONS
Specifications are in mm.
7.
FRONT BACK
Lian Li O11D Mini MK1 - Acryl Montageanleitung
Assembly Instructions